Barbecue King CLASSIC 800 Instructions Manual - Assembly of Your Classic 800
Putting Your Barbeque In An Enclosure
Any enclosure in which the appliance is used shall comply with one of the following:
Any enclosure with walls
on all sides, but at least
one permanent opening
at ground level, and
no overhead cover.
Within a partial enclosure
that includes an overhead
cover and no more than
two walls.
4
Within a partial enclosure that includes an overhead cover
and more than two walls, the following shall apply:
• At least 25% of the total wall area is completely open;
and
• At least 30% of the remaining wall area is open and
unrestricted.
In the case of balconies, at least 20% of the total of the
side, back and front wall areas shall be and remain open
and unrestricted.
Assembly Of Your Classic 800
The King Classic 800 comes to you almost fully assembled. It is constructed from premier grade materials, and is
designed as an impressive centre piece of your outdoor entertaining area.
The Left Side Shelf
Screw the side shelf to the left side of the barbeque trolley using the screws and washers provided. You will not
need any nuts - the screws feed directly into pre-threaded holes in the barbeque side panel. Depending on the
model, you may need to remove some of the screws from the side of the barbeque, and use those screws to
attach the side shelf.