Barco MFCD 1219 (TS) Installation & User Manual - 2.2 Wall Mounting
MFCD 1219 (TS) User's Guide
8
•
Keep your original packaging. It is designed for this
display and is the ideal protection during transport.
•
Avoid reflections in the flat panel to reduce eye
strain.
•
Place the display on a strong and stable table or
desk.
•
Keep the display away from heat sources and
provide enough ventilation in case it is built in a rack
or console. Do not put in direct sunlight.
•
Make sure computer and display are switched off
before connecting the signals.
•
Touch panel precautions: Operate with a stylus (tip
R0.8 or over, maximum hardness 3H), or with a
finger without applying excessive load. Sharp
edged or hard articles are prohibited. The gathering
of dew in the panel may occur with abrupt
temperature or humidity changes. A stable
environment condition is recommended. Keep the
surface clean. No adhesives should be applied.
Avoid high voltage and static charge.
2.2 Wall mounting
You can mount the panel to the wall instead of to
the foot, by means of the supplied mounting
plate. If you do not need to mount the panel to
the wall, please skip this item.
Step 1: Remove the panel from the foot
1
Position one hand under the panel at the
front side. Position the other hand at the
rear, under the push-button with BARCO
logo (9).
2
Firmly press down the push-button (9) with
one hand while carefully lifting the panel up
with the other hand.
3
Remove the panel from the foot.
Step 2: Fix the mounting plate to the wall
1
Screw the mounting plate to the wall with
the 4 supplied screws (A).