Barco PGWU-62L(-K) User Manual - page 33
33
PGWX-62L/PGWU-62L/PGWX-62L-K/PGWU-62L-K - - 2015/03/06
4. User Controls
4.1.2.4 Light Source Menu
Mode
Set light source mode of the projector.
Normal: Default value. When set to normal mode, the wattage of the laser diode will be at full power.
y
Eco: When set to eco mode, the wattage of the laser diode will be at eco power.
y
Power: Enable laser power adjust.
y
High Altitude
When “On” is selected, the fans will spin faster. This feature is useful in high altitude areas where the air is thin.
Off: Default value.
y
On: Set high altitude mode on.
y
Power
Set laser power level of the projector.
Note: Power function will not be available if you have set the laser to Eco or Normal modes.
Press the ◄ to decrease the power level.
y
Press the ► to increase the power level.
y
Constant
When “Enable” is selected, the light level will apply more power to maintain the constant brightness.
Enable: The light level will apply more power to maintain the constant brightness as the laser brightness decays
y
naturally over time.
Disable: Default value.
y
Color Calibration
Calibrate light sensor for Constant mode to work properly. It will take 3 minutes to complete the color calibration.
Light source
Mode
High Altitude
Off
Power
Normal
Constant
Enable
Color Calibration
Execute