BARIX annuncicom 100 Quick Install Manual

Other manuals for annuncicom 100: User manual
Manual is about: Network-based, stand-alone intercom system for custom home installations and commercial applications

Summary of annuncicom 100

  • Page 1

    A n n u n c i c o m 1 0 0 quick install guide version 1.2 network intercom and pa component for commercial, industrial and security applications package contents a annuncicom 100 b power supply c rca adapter for earphone d screw block terminals available cables (not included) e earphone f rca stereo...

  • Page 2

    Front view 4 1 2 3 5 6 7 1 reset button a brief press of the button will reset the device. Holding the reset button pressed in for approximately 10 seconds will reset the device and restore the factory default settings when the button is released. 2 rs-232/485 serial port (dsub 9 pin male) 3 green a...

  • Page 3

    Step 1 plug a standard (straight) network cable (not included) into the network port (c) of the annuncicom and the other end into your hub or switch.You can also use a crossover network cable (not included) for a direct connection to your pc. Step 2 a) plug the rca adapter (c) into the rca line outp...

  • Page 4

    This procedure is used to temporarily set the ip address for first time browser access to the annuncicom, in the case where you have no audio cables connected,and hence do not know the current ip address of the annuncicom. Attention: after this procedure the temporary ip will be active only as long ...