Barnstead Mega-Pure Series 798 Operation Manual And Parts List - page 8
8
Installation and Service
Requirements
Location of Unit
Choice of location for the MEGA-PURE One Liter Water Still
is primarily a matter of convenience as long as the service
requirements, listed on the next page, are met.
A.
The still may be bench or wall mounted. Allow 4"-
6" clearance at the sides and top for circulation of
ambient air to prevent buildup of heat in the cabi-
net.
B.
Unit Dimensions: 18" wide x 10" deep x 34" high.
C.
Wall Mounting: The still is supplied with slotted
mounting holes located 16" on center in the rear of
the cabinet and
22 7/8" from the bottom. The weight of the unit with
a full storage bottle is 45-60 lbs.
Service Requirements
Power
Your water still is supplied with a power cord (5 feet long) and
plug. The plug on the 120V unit requires a standard North
American 120V, 15A, 3-prong receptacle. The plug on the
240V unit requires a standard European 240 volt receptacle.
(See Figure 2.) If you do not have the required receptacle
available within 5 feet of your still, a certified electrician
should install one in accordance with local and national stan-
dards. As an alternate method of power supply for a 240 volt
unit, your electrician may remove the supplied plug and wire
the cord to a 15A-250V breaker box.
(See Figure 3.)
Water Supply Requirements
Barnstead recommends one of the following options for sup-
plying water to operate your MEGA-PURE One Liter Water
Still.
OPTION #1
A single, untreated cold water supply. The supply must be
capable of providing a minimum of 4 gallons (15 liters) per
hour at a pressure of 20-100 psi and be located within 4 feet
(1.2 meters) of the MEGA-PURE One Liter Water Still. You
must provide a shut off valve and reducer as shown in Figure
4.
Warning
Do not mount the MEGA-PURE One
Liter Water Still directly over equip-
ment that requires electrical service.
Routine maintenance of this unit
may involve water spillage and sub-
sequent electrical shock hazard if
improperly located.
Wall composition and construction,
as well as fastener type, must be
considered when mounting this
unit. The mounting surface and
fasteners selected must be capable
of supporting a minimum of 60 lbs.;
inadequate support and/or fasteners
may result indamage to mounting
surface and/or equipment. If you are
unsure of mounting surface com-
position, condition and construction,
or correct fasteners, consult your
building maintenance group or con-
tractor.
Warning
Ensure that the equipment is con-
nected to electrical service accord-
ing to local and national standards.
Failure to properly connect may cre-
ate a fire or shock hazard.
Do not connect unit to electrical ser-
vice until instructed to do so.