Baroness LM283 Owner's Operating Manual - page 11
When filling the tires with air, do not allow the
air pressure in the tires to exceed the
specified maximum.
Check that all nuts, bolts, and screws are
properly tightened to ensure that the machine
is always operated under safe working
conditions.
Keep all parts in good working condition and
all hardware tightened. Replace all worn or
damaged decals.
Check whether line connectors in the
hydraulic system are properly tightened.
Before applying hydraulic pressure, check the
connections of the hydraulic pressure lines
and the condition of the hoses.
Do not modify the machine.
Be careful durig adjustment of the machine to
prevent entrapment of the fingers between
moving blades and fixed parts of the machine.
On multi-cylinder/multi-reel machines take
care as rotating one cylinder/reel can cause
other cylinder/reels to rotate.
Use care when checking the cylinders/reels
and bed knifes.
Wear gloves and use caution when seruicing
them.
Keep hands and feet away from moving parts.
If possible, do not make adjustments with the
engine running.
Carefully release pressure from components
with stored energy.
Be sure to depressurize the hydraulic system
before performing maintenance operations on
it such as removing hydraulic equipment.
When checking the hydraulic circuit for
pinhole leaks or oil leakage from nozzles, do
not use your hands. Use items such as paper
or corrugated cardboard to find leakage
points. Be extremely careful with high-
pressure oil as it may pierce your skin,
resulting in an injury.
Do not change the engine governor setting or
operate the engine at a speed higher than this
setting. Check the maximum engine speed
using a tachometer.
Stop the engine and allow it to cool before
checking or refilling the engine oil.
When the fuel tank needs to be cleaned, do it
outdoors.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
When machine is to be parked, stored, or left
unattended, lower the cutting units unless a
positive machanical lock is provided.
Charge batteries in an open well ventilated
area, away from spark and flames. Unplug
charger before connecting or disconnecting
from battery. Wear protective clothing and use
insulated tools.
Make sure that the electrolyte is between the
“
UPPER” and “LOWER” limits. Should your
skin or clothes come into contact with
electrolyte, immediately wash the affected
area with water.
Use jack stands to support components when
required.
Appropriately manage and correctly use the
tools necessary for servicing or adjusting the
machine.
Consult a Baroness dealer or Kyoeisha when
major repairs or assistance is required.
For safety and maximum performance, use
genuine Baroness parts and accessories.
Note that the Baroness product warranty may
not apply if parts or accessories from other
companies are used.
Never store the equipment with fuel in the
tank inside a building where fumes may reach
an open flame or spark.
Allow the engine to cool before storing in any
enclosure.
When storing the machine, lower the rake.
If the engine is provided with a shut-off valve,
shut off valve while storing or transporting.
When storing the machine for an extended
period of time, remove the battery and the
ignition key. If the machine is going to be
stored with the battery still attached,
disconnect the negative battery cable.
Only cover the machine with a sheet after hot
parts have sufficiently cooled down.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
Safety
LM283
Safety
Page 1-5
Maintenance and storage