Baroness SP05 Owner's Operating Manual - page 28
27
● The hydraulic oil is extremely hot immediately after the
machine has been in operation for a long period of time.
To avoid burns, wait a short while before removing the
drain plug to change the oil.
1. Remove the drain plug from the
oil tank in a level area to drain
the old hydraulic oil.
2. Reattach the drain plug and
pour new hydraulic oil in through
the oil filler hole until the oil
level reaches the center of the
oil level gauge on the hydraulic
tank.
3. After performing a few simple
driving maneuvers and raising/
l o w e r i n g t h e r a k e , c h e c k
whether the oil level is in the
center of the oil level gauge. If
there is insufficient oil level, add
more.
Oil cap
Oil filler hole
Oil
level gauge
Hydraulic
oil tank
Drain plug
Fuel tank
Cartridge filter
●
Replacement of the cartridge filter
6-10
Inspection of parts for oil leaks
Parts such as hydraulic hose fittings, pump, and cylinder may become
loose after approximately 50 hours of operation. These parts should be
securely fastened to prevent oil leakages.
Engine
Dipstick
Oil filter
Drain plug
Oil filler hole
●
Replacement of the engine oil filter
1. Remove the old oil filter.
2. Apply a thin layer of engine oil to the gasket of the new oil filter and
screw in the oil filter until its gasket comes into contact with the
adapter. Using a wrench, turn it further 180 to 270 degrees to secure it
in place.
(* By using the optional oil filter wrench (Catalogue No. 16-5), you can
replace the oil filter without lowering the engine.)
●
Replacement of the hydraulic oil
Replacement of the
hydraulic oil
1st replacement
After 100 operating hours
2nd or subsequent replacement Every 500 operating hours
Replacement of the
cartridge filter
1st replacement
After 100 operating hours
2nd or subsequent replacement Every 250 operating hours
Designated hydraulic oil
Shell Tellus 46 hydraulic oil or equivalent
Oil tank capacity
Approx. 15 L
6-9
Replacement of the hydraulic oil and the cartridge filter
● Contaminated hydraulic oil will cause the hydraulic equipment to fail.
Replace the hydraulic oil and the cartridge filter periodically.
● Drain and replace the hydraulic oil immediately if you
notice that it is emulsifying or that there is a lack of
transparency.