Barricade SMC7008ABR Installation Instructions Manual - page 7
9. At this point the LAN side of your Barricade is configured. The next step is to
configure the Virtual Server information.
10. Under Advanced Settings click Virtual Server. Type the reserved Static IP address
for the FPM/GPM workstation, type 5069 for the LAN port and 5069 for the public port
number and choose TCP for the Protocol type. Click “Add”.
FPM/GPM Workstation IP Address =
192.168.2.99
FPM/GPM Workstation Subnet Mask =
255.255.255.0
FPM/GPM Workstation Default Gateway = 192.168.2.1
11. The next few steps will be to configure the Barricade router for Internet access. There
are generally two different configurations used by most ISP’s.
• If you use a DSL Modem your ISP probably requires you to manually enter
your TCP/IP settings. If you have a DSL connection or if you know you use a
Static IP address please move to “Part B - Configuring Your Barricade for
Static IP Address”.
• If you connect to the Internet using a Cable Modem your ISP provider probably
used DHCP to issue an IP address to you. If you use a cable modem or you
know that the ISP uses dynamic IP address please move to “Part C -
Configuring Your Barricade for a Dynamic IP Address.