Bartell BSM1402 Owner's Manual - page 17
BSM1402 MASONRY SAW
OI
– B19042
OWNER
’S MANUAL
16
•
Rinse the immersion pump with fresh water to prevent the water pump from clogging with
residual dirt.
After wet cleaning and b efore using the machine again:
•
Connect the machine to an electric power outlet equipped with a
“GFCI” safety power breaker.
If the safety power breaker cuts off the electrical power supply, do not try to operate the
machine but have it checked by an authorized dealer first.
Prolonged Period of Non-use
Before not using the machine for a prolonged period of time:
•
Clean and lubricate all movable parts. However, do not grease the guide rails.
After not using the machine for a prolonged period of time:
•
Check that the stand is safely fixed.
•
Check that all screw joints and nuts are fixed.
•
Check that the cutting table is seated properly on the guide rails and that it moves easily along
the entire length of the rails.
•
With the saw blade removed, switch on the motor for an instant and switch it off again. If the
motor does not run, have the machine inspected by a qualified electrician.
•
Check that the immersion pump works properly. Turn on the cooling water tap and switch the
machine on. If the pump does not give any water or only a little, switch the machine off at once.
Clean the pump, or replace if necessary.
Extreme Temperature
Ambient temperature below 32° F (Winter):
•
To prevent the water in the pump and cooling system from freezing, remove the water after
using the machine or when there will be a long break. Make sure that the cooling system is
entirely drained so that there is no water left inside the pump and water hose!
Water Pump Maintenance
When the machine has not been used for a long period of time, hard packed dirt may begin to
build up inside the pump and block the pump wheel. If the machine is activated with the
immersion pump blocked, the electric motor of the pump will be damaged within a few minutes!
Please follow the steps listed below to clean the pump before operating the saw:
1.
Remove the immersion pump from the water container.
2.
Clean the immersion pump.
3.
Loosen the screws of the pump lid.