Basbau Innovation BB–202 Black Digital Instruction Manual - page 7
10
If you have seen the opening screen, but nothing afterwards,
1.
Please check if your Camera unit is turned on. The green Power LED will light up and
indicated the system is on.
2.
Make sure the Camera unit and Monitor Unit are within range of each other. For
trouble shooting purpose, you should remove all the obstacles between two units,
and keep shortest distance. (within 5 meters)
3.
Press the ‘P’ button and scan through 4 pre-set camera ID to make sure your Camera
Unit was not paired to other pre-set ID.
4.
Pls. remove the battery and unplug the A/C adapter. Wait for 10 minutes. Plug the
A/C adapter back to the Monitor Unit and retry to power on the Monitor Unit.
5.
If all above steps fail, you are advised to pair the Monitor Unit and Camera Unit. Pls.
following the steps mentioned in Pairing/Adding Camera Unit.
If the screen displays the below picture,
1.
The Monitor Unit may be out of the
signal coverage from the Camera Unit.
Remove the obstruction or get closer to
the Camera Unit, until the blue LED is on,
will re-gain the signal automatically.
2.
Try to place both antennas vertically. It
gives better effectiveness of signal
transmission.
3.
Other 2.4GHz or high frequency devices (like WIFI, microwave oven) may interfere
the monitoring system. Turn off these devices will give better performance.
4.
Press the ‘P’ button and scan through 4 pre-set camera ID to make sure your Camera
Unit was not paired to other pre-set ID.
Video problem
1.
Try to adjust the brightness level by pressing the brightness (+/-) button until it gives a
desirable image.
2.
If the colour goes off, it indicates that the Camera Unit is working in a dim area, and
the night vision (Infra-red) function is on.
Sound problem
1.
Try to adjust the volume level by pressing the volume (+/-) button until it gives a
desirable sound level.
2.
If you have heard the shrill sound (feedback), you placed the Monitor Unit and
Camera Unit too close. Place them apart or lower the volume level will solve the
problem.
Do not attempt to open the casing of the system or the battery. Improper use of the system
will cause fatal damage. Moreover, the warranty will be void.
11
Basbau Innovation declares that the BB - 202 Black Digital is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. This
declaration of conformity may be consulted at:
www.basbau.com/declarationofconformity/1999/5/EC=8437012400016/bb202blackdigital.pdf
Por la presente, Basbau Innovation declara que BB - 202 Black Digital cumple con los
requisitos esenciales y otras exigencias relevantes de la Directiva 1999/5/CE.
Pueden consultar la declaración de conformidad en:
www.basbau.com/declarationofconformity/1999/5/EC=8437012400016/bb202blackdigital.pdf