Bastl Instruments Little Nerd Assembly Manual - page 10
Manual is about: v1.1 Clock Trigger & Gate Processor Module
of
12
MOUNTING OF THE BOARDS
You are almost done now. You have to finally
connect all the boards together. Take the bottom
board and connector board first.
Prepare two 3
pin headers (male and female), two 2x3 pin
headers (male and female) and pair them
together as shown on the picture. The female
headers goes on the bottom board. Use
two 11
mm spacers and four screws to get the boards
together. Now solder both female and male
pinheaders.
Now prepare
two female headers (5 pin, 8
pin)
. Press it on pots board male headers and
then take the two units, put them together
(use the last screw for mounting) and solder
the female headers on bottom board.
10