Bastl Instruments Little Nerd Assembly Manual - page 8
Manual is about: v1.1 Clock Trigger & Gate Processor Module
of
12
Then solder two
IC sockets (1x 14 pin, 1x 28 pin).
Make sure that the notch on the socket matches
the print on the board
.
Now let’s do some other parts. There are
three 100nF capacitors (marked 104),
one protective fuse
(it looks quite similar to a ceramic capacitor but is placed in the “PTC” rectangular) and one
16MHz
resonator
(the orange component with 3 leads). None of these parts are polarized so you can insert
them in any direction.
It is time for more capacitors. Insert two
10μF
electrolytic capacitors and solder them.
However be careful,
these are polarized!
There is a plus (+) sign on the PCB that should
match the longer lead of the capacitor (actually
the minus (–) side is also marked on the body of
the capacitor with a white strip).
8