Batavia 7062246 Operating Instructions Manual - page 16

English

16

.

OPTION 1: WEED KILLER

Assemble the extension handle

The extension handle consists of two parts. 

Connect both parts and tighten the 

connection.

Now attach the extension handle to the device.

Make sure that the extension handle firmly 

clicks into position. If using the device as a 

weed killer you must use the extension handle. 

Hold the weed killer firmly by holding the end 

of the extension handle.

Use:

•  Ensure the extension handle is firmly fixed 

onto the device and that the device is 

turned off.

•  Turn the device to position 1 (see Fig. D)

•  Install the nozzle (11) to destroy weeds.

•  Insert the plug into the socket

•  Check to ensure the nozzle is not blocked 

before turning the device on.

•  Set the temperature to setting II or III.

•  Allow the device about 45 seconds to 

warm up.

•  To eliminate weeds, hold the nozzle over 

the weeds for about 5 seconds. During 

these 5 seconds the cell structure of the 

weed is destroyed. As a result, the weed 

dies within a few days.

•  It is not necessary to completely burn the 

weeds, 5 seconds is more than sufficient.

•  For an efficient treatment the nozzle 

should be held around 0 to 5 cm above 

the weeds

•  The effects are not visible immediately but 

will take a while before they can be seen. It 

is more of a long-term effect.

OPTION 2: PAINT REMOVAL

The paint removal is always done without the 

use of the extension handle. Remove the 

extension handle by pressing and releasing 

button (7) and pulling the extension handle 

from the device.

The paint removal can be used for various 

purposes, such as:

•  Removing old paint and gloss

•  Removing self-adhesive labels

•  Bonding of PVC labels

•  Removing vinyl wallpaper

•  Fast drying of damp equipment

•  Shrink packaging

•  Defrosting of water pipes

•  Loosening of nuts and bolts

The following standard nozzles are included:

•  Glass protection nozzle (13): For the 

removal of paint and gloss from window 

frames, protecting the window and panes.

•  Flat nozzle (12): For a better hot air 

distribution.

The device can also be used without a nozzle 

attachment.

Use:

•  Remove the extension handle

•  Turn the device to position 2 (Fig. D)

•  Attach the desired nozzle onto the device.

•  Insert the plug into the socket

•  Check to ensure the nozzle is not blocked 

before turning the device on.

•  Set the temperature to setting II or III.

OPTION 3: BBQ / FIREPLACE LIGHTER

The BBQ and fireplace lighter is always to be 

used without the extension handle. Remove 

the extension handle by pressing and releasing 

button (7) and pulling the extension handle 

from the device.

Use:

•  Remove the protective cap (9) from the 

device.

•  Attach the BBQ nozzle onto the device

•  Select temperature setting III.

•  Place the nozzle under the coal or the 

wood.

•  Ensure that the firelighter is properly 

positioned

•  Insert the plug into the socket

•  Check to ensure the nozzle is not blocked 

before turning the device on.

•  Remove the device from the coals or the 

wood as soon as it starts to glow

7062246_Maxxheat_Ma_#1503-18.indb   16

10-12-15   11:03