Battery Fighter bca1702wr Instruction Manual - page 6
BCA1702WR - 140717
glowing
MODE
Press the MODE button for the program of Car Memory Saver function
CAR MEMORY
SAVER
Connect the OBDII plug to the OBDII port of the car for data backup during battery
replacement. (Location of OBDII underneath the dash board or beside the fuse box) The
Power & Car Memory Saver LEDs will be glowing during operation.
ATTENTION: PLEASE ENSURE THE PROPER CONNECTION, CAR MEMORY SAVER
& POWER LEDs ARE GLOWING BEFORE BATTERY REPLACEMENT, OTHERWISE
THE ELECTRONIC DATA WILL LOSE!
TROUBLE SHOOTING / MESSAGE LIGHTS CHECKLIST:
NO indicator lights are on.
A. Disconnect the charger from the AC outlet. Check connections to battery
and ensure they are good.
B. Check to ensure that there is power at the AC outlet by plugging in a table
lamp or power meter.
Power Light On but the charging light is off
A. Battery is not connected
B. The battery may be damaged or below 3.0 volts, charge process will not
begin.
In this case the “Bad Battery” light will be on or the charger remains at
Standby mode.
Recovery Light - On
A. Battery recovery mode is in process
B. The battery is being recovered; wait until the Recovery
Light turns off, then normal charging processes will begin.
Bad Battery Light - On
The battery is worn out or is possibly defective. Suggest replacing battery
with a battery.
The charger is charging but the Fully Charge /
Maintenance light does not come on
A. The battery is worn out or is possibly defective. Suggest testing and/or
replacing battery with a battery.
B The battery may have an excessive current draw caused by a potential
short circuit. Disconnect battery from charger. Suggest testing and/or
replacing battery with a battery.
C. The charged battery is larger than the charger marked capacity (shown in
manual) Please recharge with larger capacity charger.
Pb Charging mode (Lead
–Acid Battery Charging Mode)