Bauer 1632E-B Owner's Manual & Safety Instructions - page 11
Page 11
For technical questions, please call 1-888-866-5797.
Item 63438
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Mounting chisels with a collar
1. IMpORTANT! Wipe clean, then grease chisel’s
shank using included chisel Grease.
Note: Keep chisel shank clean. Do not lay in dirt or dust.
2
3
Retaining
Ring
4
Figure E
2. Pull the Lock Lever open about 70-80° to the
second engaging position, as shown in Figure F.
Figure F
3. Insert the collared Chisel.
4. Slide the Chisel in as far as it will go.
5. Return the Lock Lever to its original position
to lock the Chisel in place. See Figure G.
Figure G
6. Physically check that the Chisel is secure
before operating. The Chisel will have play,
but should not come out when pulled.
Work piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Trigger is in the off-position,
then plug in the tool.
2. Once the chisel is installed and the
Auxiliary Handle set in the desired position,
set the tip of the bit against the work area.
3. Place one hand on the Auxiliary Handle and
the other hand around the Main Handle.
4. Press the Trigger to activate the
Demolition Hammer.
5. WARNING! Once activated, do not press, bear down
or thrust forcibly against the work surface. Hold the
Demolition Hammer with just enough pressure so
that the tool’s own weight supplies the needed force.
NOTE: If the Demolition Hammer has not been
used for a long period of time or is being used in
low temperatures, the tool should run for about
two minutes before achieving full performance.
Make sure the Trigger properly actuates when pressed
and that the tool turns off when its released.
NOTIcE: Avoid operating the tool without pressing the
bit against an object. Doing so will damage the tool.
6. When work is complete, release the Trigger.
7. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.