Bauhn HE21404 Instruction Manual - page 9
9
After Sales Support - Help Desk
Telephone:
1300 663 907
Internet:
www.winplus.com.au
B.
Masonry Mounting:
Included with the kit are 4 x 54mm x Ø7.5mm masonry anchors.
a. Hold the faceplate against the masonary then mark the area with a pencil
to note the location of the mounting holes.
b. You will need to drill a hole into the masonry using a masonry drill bit, no
deeper than 36mm. The hole must be able to fit in the Ø7.5mm masonry
anchor but be no wider than 8mm to allow the anchor to take hold inside
the hole.
c. Place the faceplate against the masonry.
d. Insert the anchors through the holes in the faceplate, into the holes you
have drilled.
e. Use a 10mm socket wrench to tighten the anchors, securing the faceplate.
Note: You can mount the faceplate vertically or horizontally as shown.
Note that this will affect the angle of motion that you will be able to adjust
the antenna to.
2. Insert the mounting pole into the faceplate, then insert screws through
the pivot hole and the variable adjustment slot. Tighten these screws to
securely attach the mounting pole to the mounting plate.
Note: You can mount the mounting pole by attaching the longer or shorter
end to the mounting bracket. Choose the best method of installation for
your antenna scenario.