BionX G2 User Manual - Chargers
15
PL-250HT (EU) / PL-350HT (NA) systems charging
procedure, 2012 - present (single light charger)
• Connect the charger and battery by inserting the
charge connector into the charge port. The system
should be turned off
• Connect the plug of the charger with the power outlet
• The light on the charger will turn red automatically
• The same light will then turn yellow to indicate
charging, a fully depleted battery will take 4-5 hours
to charge
• The light will turn green, the battery is then fully
charged and the charging process is complete
• Following this procedure, the charger should be
disconnected
PL systems 22.2V, 26V, 37V charging procedure,
2011 and earlier (two LED charger)
• Connect the charger and battery by inserting the
charge connector into the charge port. The system
should be turned off
• Connect the plug of the charger with the power outlet
• The power switch must be set to ‘on’ and the red LED
will illuminate
• The LED to the right of the red LED will illuminate
yellow to indicate charging, a fully depleted battery
will take 4-5 hours to charge
• The right LED light will turn green, the battery is then
fully charged and the charging process is complete
• Following this procedure, the charger should be
disconnected
WARNING
Check input voltage when travelling with charger,
or using any outlet adaptor. Failure to adjust the
voltage switch on a two LED charger to the cor-
rect voltage range can result in damage to your
charger.
001
115
FUSE
This notch is very important
NOTE
The 37V single light charger is suitable for the voltage ranges 110-115V or 220-230V.
There is no need to manually set the voltage range, and there is no switch for this charger.
Left LED = red,
charger on
Right LED =
yellow, charging
Right LED =
green, fully charged
001
115
FUSE
This notch is very important
Chargers
001
115
FUSE
This notch is very important