BionX PL250HT SL XL User Manual - page 12
12
Programming the Basic Settings
In general, all basics settings for your BionX electric propulsion system are pre-set. Basic display functions
can be set by entering the programming mode. Contact your dealer to customize the advanced functions of
your system.
Turn on the programming mode
Simultaneously push and
until the display shows “0000”. The first zero blinks. Change the value
of the selection with or and confirm with . Select the other digits in the same manner until the
desired program is displayed.
Code
Description
2001
Select km/h or mph
2002
Regeneration/brake output (for magnetic switch) 0-40
(ideally 30-40)
2005
Tire circumference (millimeters)
2009
Flip Display Plus/Minus 0 = power left, 1 = power right
Code 2001
Code 2002
Select unit - km/h or mph. Select with
or and confirm with
.
Default value: 30: adapt with
and . Confirm with
.
Code 2005
Code 2009
Set tire size (in mm) - Select digits
one after another with or and
confirm with
.
Current setting of main functions is
displayed. Flip = 0, assist toggle is on
the right side of console; Flip = 1, assist
toggle is on the left side of console.
Confirm with
.
WARNING
Please do not use other programming codes without
consulting your authorized dealer.
If you type the wrong code, please push key to exit
programming mode.