BioZone MZ-II (Heavy Duty) Owner's Manual - Operation:
PhotoPlasma lamp replacement:
Disconnect power. ATTENTION!
The unit and the UV-lamp must be allowed to
cool down before replacement.
Unfasten the screws on the underside of the unit and open the case.
Carefully remove the old lamp from its socket by holding the socket with one
hand and the lamp with the other.
Connect the new lamp to the socket and replace lamp in clamps.
Avoid touching the new lamp glass with bare fingers.
Reassemble the case and tighten the screws.
Dispose the old lamp according to local standards.
PhotoPlasma lamp cleaning:
Open the unit in accordance with the lamp replacement instructions in this
manual. ATTENTION!
The unit and the UV-lamp must be allowed to cool down
before cleaning.
Carefully remove the lamp from its socket by holding the socket with one
hand and the lamp with the other.
Avoid touching the lamp glass with bare fingers.
Clean the lamp with a soft cloth and an appropriate cleansing solvent.
Reinsert the lamp.
4.
Operation:
Plug the small end of the power cord into the unit and plug the other end into your
vehicle power receptacle. The unit turns on automatically when power is
connected. The unit does not have a separate on/off switch. If you want to turn the
unit off, unplug the unit from the power receptacle or the unit.
5.
Air Purifying strength:
Model: MZ-I / MZ-II (Heavy Duty) Area: For Vehicle Use Only
CAUTION: MZ'
s designed for: Passenger cars, small SUVs, large SUV’s, vans
and semi-trailer truck only. May also use as traveling unit for a small hotel/motel
room
– adapter required (optional)