Bircher Reglomat ProLoop Operating Instructions
ProLoop loop detector DIN variant, mounting rail installation
ProLoop loop detector 11-pin, base mounting
LCD display
«Mode» button
«Data»-button
Terminals
Info LED
1
Pro
Loop
Loop detector for industrial doors and gates,
car parks and parking bollards
Quality
international
level
EN ISO
9001
2
Mechanical mounting in the switch cabinet
3
Electrical connection
ProLoop DIN variant terminal connection diagram
Operating instructions
Safety instructions
1
General
These devices and their accessories may only be operated in compliance with the operating instructions (intended use)!
These devices and their accessories may only be commissioned by trained and qualified personnel.
These devices may only be operated with the intended operating voltages and parameters.
If malfunctions occur that cannot be rectified, shut down the device and send it in for repair.
These devices are only allowed to be repaired by the manufacturer. Tampering and alterations are not permitted. This will invalidate all guarantee and
warranty claims.
The ProLoop DIN variant is mounted on a 35 mm mounting rail acc. to EN 50 022 in the switch cabinet. In the ProLoop, the terminals are pluggable and
coded. The 11-pin version of the ProLoop is mounted onto a mounting rail base (ES 12). This base is ordered and delivered separately as it is not included
in the scope of delivery.
A:
Supply
voltage
connection
B:
Loop connection
1-channel device
C:
Loop connection
2-channel device
D:
Alarm output
connection
(optional)
E:
Relay connection
output 1
F:
Relay connection
output 2
AC
AC
A1
A2
31
32
34
no
nc
common
14
11
12
no
nc
common
24
21
22
no
nc
common
L3
L4
L3
L4
L5
L6
1
2
The loop connection wiring to the loop detector must be twisted at least 20 times per meter.
Please wire the device in accordance with the terminal assignment. Make sure the terminals are assigned correctly.
Check the electrical connection (base assignment) when exchanging a loop detector from another manufacturer.
1-loop device
Relay assignment:
Output connection
diagram:
Output 1
E
Output 2
E, F
Alarm output
D, E, F
2-loop device
Relay assignment:
Output connection
diagram:
Output 1+2
E, F
Alarm output
D, E, F
Output connection options (depending on the options ordered):
1-loop device
Relay assignment:
Output connection
diagram:
Output 1+2
D, E
2-loop device
Relay assignment:
Output connection
diagram:
Output 1+2
D, E
Output connection options (depending on the options ordered):
3.1
A:
Supply
voltage
connection
B:
Loop connection
1-channel device
C:
Loop connection
2-channel device
D:
Relay connection
output 1
E:
Relay connection
output 2
AC/DC
AC/DC
A1
11
22
A2
21
no
nc
common
14
31
12
no
nc
common
32
24
34
32
24
34
1
2
ProLoop 11 terminal connection diagram (ES 12 base assignment)
3.2