BIS ULTIMA-1 506128-23 Installation And Operation Instructions Manual - page 3
TABLE OF CONTENTS
SAFETY RULES and Specifications for
Mobile or Manufactured
Home Installation .........................Page 2
Introduction ......................................Page 3
Parts Required .................................Page 3
Optional Equipment ...........................Page 3
Operating The Fireplace ....................Page 4
Fuel ...................................................Page 4
Combustion Control .........................Page 4
Refueling For Best Performance .......Page 5
Smoking – Causes And
Troubleshooting ..............................Page 5
Important Cautions ...........................Page 5
Maintaining Your
BIS
®
Ultima-1 Fireplace ...................Page 6
Chimney Maintenance .......................Page 6
Dealing With A Chimney Fire .............Page 6
Finish Door Casing Care ....................Page 6
Disposing of Ashes ...........................Page 6
Refractory Replacement ....................Page 7
Door Installation ...............................Page 7
Door Adjustment ...............................Page 7
Glass Care - Replacement .................Page 8
Glass Care - Cleaning ........................Page 8
Gasket Replacement ........................Page 8
Fireplace Installation ........................Page 8
Locating The BIS Ultima-1 Fireplace .Page 8
Framing, Facing And Mantel ..............Page 9
Hearth Extension Requirements .......Page 9
Cold Climate Installations ..................Page 9
Fireplace and Framing Dimensions ...Page 10
Insulated Chase Construction ...........Page 11
Nailing Flanges ..................................Page 11
Facing / Mantel ..................................Page 11
Hot Air Ducting Installation ..............Page 12
Gravity Kit .........................................Page 12
Central Forced Air Kit Installation ......Page 13
Outside Air Kit ..................................Page 14
Chimney System ...............................Page 15
Chimney Installation Notes ...............Page 15
Chimney Installation Instructions ......Page 16
Offset Chimney Installation ...............Page 17
Angled Wall Radiation Shield ............Page 19
Chimney Support Installation ............Page 20
Chimney Chase And
Multiple Terminations......................Page 20
Chimney Adaptor ..............................Page 20
Masonry Application Instructions .....Page 21
Installation Accessories ....................Page 22
Replacement Parts ............................Page 23
Specifications ....................................Page 23
Clearances to Combustibles ..............Page 23
Chimney Components Lists ..............Page 24
Product Reference Information .........Page 26
THE FIREPLACE
INTRODUCTION
The BIS
®
Ultima-1 wood-burning fireplace is
an energy efficient, heat circulating, closed
combustion fireplace. You will receive a lifetime
of comfort and enjoyment from your fireplace
provided it is installed, maintained and oper-
ated properly.
• Please read these instructions and retain
this manual for future reference.
• Before beginning the fireplace installation,
consult the local authorities to obtain your
building permit and check your local building
codes. Install the fireplace only as described
in these instructions and using only IHP
components.
• This fireplace has been tested for CAN/ULC
S610-M87 and ANSI/UL 127 under report
number 3011202. It has also been tested
for EPA 40 C.F.R Part 60, section 60.532(b).
Certificate number 537.
• The BIS Ultima-1 fireplace is not intended
for use with a gas log set. Do not use a
fireplace insert or any other product with
this fireplace unless it is specified by IHP
for use with this appliance. Failure to follow
these instructions will void the certification
and the warranty of the fireplace and may
result in an unsafe installation.
• IHP wood fireplaces are designed for use as
a supplemental heater. They are not intended
for continuous use as a primary heat source.
PARTS REqUIRED
Fireplace Model BIS Ultima-1
•
.
Decorative Cast Iron Door - Required
...
(Order Separately - see Page 22)
•
.
Outside air kit - Required
...
(Included w/Fireplace)
• . 6” diameter chimney
*
- model ASHT+,
S2100+, HT6000+, HT6103+ or AC manufac-
tured by Security Chimneys International™
only, including:
- Chimney lengths
- Elbows (where necessary)
- Associated components as per these
installation instructions
OPTIONAL EqUIPMENT
• Additional Equipment (optional)
- AC Chimney Adaptor
*
(required if using AC Chimney)
- AC chimney outside air kit
- Gravity venting system
- Panel for clean face option
(only with gravity venting system)
- Forced Air Kit
u
- Rigid firescreen
- Fireplace Blower Kit
- Blower Speed Control
u
Not tested under EPA certification. If in-
stalled, this appliance no longer qualifies
for EPA certification.
CONGRATULATIONS!
When you purchased your new wood fireplace, you joined the ranks of thousands of
individuals whose answer to their home heating needs reflects their concern for aesthetics,
efficiency and our environment. We extend our continued support to help you achieve
the maximum benefit and enjoyment available from your new wood fireplace.
Thank you for selecting an IHP wood fireplace as the answer to your home supplemental
heating needs.
*
Available from Security Chimneys™
3