Bissell 1305 SERIES User Manual - Maintenance:

www.BISSELL.com

9

WARNING

Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt 

Container in place. Allow components to dry before reassembling the Dirt Container.

Maintenance: 

Replace the Brush & Belt

1

3

2

Unplug vacuum, turn over and 

unscrew 7 Philips head screws 

to remove bottom cover

Pull roller straight 

out, threading 

through belt

Replace roller and/or belt. 

To reassemble roller, thread 

through belt and line up End 

Cap, then place bottom cover 

back on and replace 7 screws.

End Cap

Belt

Maintenance: 

Maintain the TurboBrush®/

TurboEraser® Tool

1

3

2

If paddle wheel gets dislodged, 

align two clips on each side and 

pop into place

Twist gray collar  

counter-clockwise, until 

slot appears, and then 

separate faceplate 

Carefully remove brush, 

replace belt and brush, 

if needed

Faceplate will not 

close properly if all 

parts are not aligned 

correctly

*images may vary

TurboBrush

Align

Slot

Paddle Wheel

Roller

Belt

Paddle Wheel End

Clip

NOTE: If an object becomes lodged in foot and brush shuts off, turn vacuum  

off and unplug from electrical outlet. Remove obstruction and brush will 

automatically reset when vacuum is plugged and turned back on.