Bissell 1305 SERIES User Manual - Handle Assembly
www.BISSELL.com
5
Assembly
Operations
No tools required for assembly.
Handle assembly
1. Press the handle adjustment lever and slide
the handle into the vacuum base
2. To remove the handle, press the handle adjust-
ment lever and pull handle out of vacuum base.
NOTE: The handle has two height settings.
To lower or raise the handle, push the handle
height adjustment lever and slide the handle up
or down until it locks into the desired place.
3. Attach the lower cord wrap to the lower
back of unit by snapping in place.
4. Attach the extra reach stair hose to the
back of the unit.
Note: The handle of your vacuum can also
be used as an extension wand. Follow
instructions on page 7 to attach cleaning hose
and attachment.
Power switch
1. To turn on the vacuum, locate the power
switch and move it to the “on” position (I)
2. Once cleaning is complete, turn the vacuum
off by switching it to the (o) position.
Brush switch
1. For carpet cleaning, turn on the brushroll by
moving the button to the brush position.
2. For hard surface cleaning, turn the brush off,
by switching it to the (o) position.
NOTE: The brush roll will automatically shut
off in the following scenarios:
1. When the vacuum is locked in the
upright position.
2. If large debris is clogged in the brushroll.
In this instance, the brush will completely power
off disabling both the brush roll and the brush
roll switch. Follow instructions on page 11 to
reset the brush.
CAUTION
Before using your vacuum, make sure that
the dirt container is in locked position and
that all filters (pre-motor and post-motor)
are in place. Do not operate your vacuum
without these filters.
1.
3.
2.
4.
WARNING
Do not plug in your vacuum cleaner until
you are familiar with all instructions and
operating procedures.