Bissell 1660 User Manual

Manual is about: Big Green canister style carpet cleaner user's guide

Summary of 1660

  • Page 1

    Big green series ■ assembly ■ operation ■ safety ■ storage ■ 3 in 1 multi-purpose deep cleaner ■ more powerful suction than upright deep cleaners ■ lightweight wand easily maneuvers under and around furniture ■ 8 specialized attachments for all cleaning needs user’s guide we’re glad you purchased a ...

  • Page 2: S Ave These Instructions

    ■ use only manufacturer’s recommended attachments ■ use only cleaning products formulated by bissell for use in this appliance. ■ use dry filter bag or motor filter when dry vacuuming ■ keep openings free of dust, lint, hair, etc. ■ keep appliance on a level surface ■ turn off all controls before un...

  • Page 3: 13.

    13. 14. 15. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Ball ball cage motor filter measuring cup tank unit top power unit aluminum wands floor nozzle grip/trigger unit wand solution tube small wand clips vacuum flex hose hose with threaded connectors large vacuum flex hose clips tank siphon tube casters...

  • Page 4: How to Use This Guide

    4 casters. Locate 4 casters inside plastic packaging in collection tank. Turn tank unit upside down. Insert four casters and push until they snap into place. Ball. Place ball on raised area of recovery tank bottom. [note: ball may have an unusual color due to recycled high density polyethylene (hdpe...

  • Page 5: Index

    Wand solution tube. Connect wand solution tube to spray tip on floor nozzle and to cap valve on grip/trigger unit. Small wand clips. Secure tube to wand with two small wand clips. Vacuum flex hose. Connect vacuum flex hose to grip/ trigger unit and lock with latch buttons. Insert vacuum flex hose in...

  • Page 6: How to Begin...

    1. Vacuum carpet (see page 9, how to dry vacuum). 2. Decide where to begin — and end — your job. Clean in 3’ x 4’ sections, starting in areas farthest from exit. Plan to leave a path open to empty collection tank and replenish filling cavity. 3. Carpeting will dry in two to four hours, depending on ...

  • Page 7: How to Deep Clean Carpet

    How to deep clean carpet getting ready 1. Remove dry filter bag from ball cage. 2. Remove concentrate measuring cup from filling cavity on side of tank unit. 3. Pour two gallons of hot tap water (temperature should not exceed 120° f/48° c) into filling cavity until level reaches bottom of three vert...

  • Page 8

    1. Disconnect wand solution tube and aluminum wands from grip/trigger unit. 2. Moisten o-ring at base of cap valve with soapy water. 3. Align small area cleaning nozzle with cap valve and vacuum tube on grip/trigger unit. 4. Press latch button on vacuum tube and slide small area cleaning nozzle on u...

  • Page 9: How to Dry Vacuum

    Getting ready 1. Attach bare floor attachment to bottom of floor nozzle with rubber and brush strips facing out. Align front edges and snap together. 2. Fill measuring lid twice with bissell floor care and empty into filling cavity. 3. Pour two gallons of hot tap water into filling cavity. Water lev...

  • Page 10: How to Wet Vacuum

    How to wet vacuum 10 tip: clean water spills can be picked up from surfaces directly. No cleaning solution is necessary. Vacuum/suction switch getting ready 1. Remove dry filter bag from ball cage. 2. Place ball on raised area on bottom of tank unit. 3. Position ball cage over ball and press firmly ...

  • Page 11: Putting It Away

    11 after deep cleaning/wet vacuuming 1. Rinse filling cavity with clean water. Leave about 1/2 gallon of clean water in filling cavity. 2. Hold floor nozzle over bucket or sink. 3. Turn on pump/spray switch, pull trigger for 30 seconds, and empty power unit. 4. Empty filling cavity of excess water. ...

  • Page 12: Troubleshooting

    Possible causes remedies vacuum is not operating check electrical plug vacuum/switch on? Call bissell consumer services (see page 14) collection tank unit is full empty collection tank air leak check all vacuum connections secure all latch buttons dirty filter(s) see putting it away, after dry vacuu...

  • Page 13

    Part numbers and descriptions 13 item part no. Part name 1 010-4706 vacuum flex hose 2 013-2477 large vacuum flex hose clips (3) 3 010-4697 hose with threaded connectors 4 016-4181 grip/trigger unit 5 010-1188 dusting brush 6 010-9156 crevice attachment 7 010-6055 small vacuum nozzle 8 603-1659 cap ...

  • Page 14: About Your Warranty

    About your warranty bissell consumer services this warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, call bissell consumer services...