Bissell 89Q9/18Z6 series User Manual - Aintenance and Care
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
11
M
aintenance and care
cleaning the secondary cyclone
Unplug the cleaner from electrical outlet.
1. The secondary cyclone can be reached by
removing the dirt container, reaching
underneath the upper tank and turning the
rim of the frame to unlock. Pull straight down
to remove.
2. The cyclone and screen may be separated
for cleaning. Simply pull up on the screen
to separate.
3. The upper tank may also be wiped clean
with a damp cloth.
1. Unplug the vacuum from electrical outlet.
2. The pre-motor filter protects the motor from
dirt particles. It is located in the slide out
tray underneath the dirt container. If the
filter becomes dirty, pull out the tray, lift
out the filter and clean. This filter may
be hand washed in cold water with mild
detergent. Rinse well and air dry
thoroughly before replacing.
3.
The post-motor filter assists in the filtration
process to return clean air to the room.
It is located behind the door on the back
of the cleaner. If the filter becomes dirty,
open the door, remove the filter and replace.
note: the post-motor filter is a
white, pleated filter. this filter is not
washable and must be replaced
when it becomes dirty.
Tip:
Select models include a Febreze®
post-motor filter instead of a HEPA
Media Filter*. This Febreze® filter
is compatible with all BISSELL
Lift-Off MultiCyclonic vacuums. For
ordering information, please refer
to the Replacement parts information
on page 17.
cleaning the pre-motor and post-motor filters
1.
2.
3.
2.
WaRning:
Do not operate cleaner
with damp or wet filters
or without all filters in
place.
Pre-Motor
Filter
Post-Motor
Filter
* The filter media, not the vacuum as a
whole, complies with the IEST-RP-CC001.5
HEPA standard.