Bissell AeroSwift™ Compact Vacuum User Manual - Replace Drive Belt
www.bissell.com
800.237.7691
Replace drive belt
1. Unplug the vacuum from electrical outlet.
2. With rotating brush removed (follow steps
from check rotating brush section), grasp old
drive belt and remove from motor pulley. if
difficult to remove from pulley, use scissors to
cut and remove belt.
3. Place the new drive belt over motor pulley
and loop other end over rotating floor brush
in the space between bristles.
notE: the space between the motor pulley and
the foot covering is tight. Slide the thin side of
the belt down between the motor pulley and
foot covering and work with your fingers to
position under the motor pulley.
4. With drive belt connected to motor pulley,
pull the belt over the brush roll and position the
floor brush into the brush cover ends. Rotate
the brush end opposite of the belt to line up
with the brush cover tab. The brush end closest
to the belt will slide in the tab without needing
to rotate.
5. Replace brush cover and secure with the
3 screws.
check and clean filter
The vacuum comes with a standard foam filter
(yellow) located in the filter tray. A Febreze®
foam filter (black) is packed into the box in a
protective plastic bag. Replace the standard
filter with the Febreze® foam filter to eliminate
odors and freshen as you vacuum.
1. Unplug the vacuum from electrical outlet.
2. The foam filter is located in the slide out filter
tray underneath the dirt bin. it is recommended
to check the filter regularly and remove any dirt
or debris build up in the tray after or before use.
3. both the standard yellow foam filter and the
Febreze® (black) foam filter are washable. Hand
wash in cold water with mild detergent. Rinse
well and air dry thoroughly before replacing.
notIcE: overtime with use and washing, you
will begin to notice a loss of scent strength as
you vacuum with the febreze® filter. Even with
loss in scent, if there is no wear to the foam,
the filter will continue to work effectively
by protecting the motor from dirt particles.
contact bISSEll consumer care to order
replacement filters.
12
Maintenance & Care
WaRnInG
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
3.
3.
4.
WaRnInG
Do not operate cleaner with damp or wet filters
or without vacuum bags and all filters in place.