BulbAmerica iLED-24 User Manual - 4. O

Manual is about: BulbAmerica iLED-24 Dj lighting

Summary of iLED-24

  • Page 1

    Iled-24 user manual snapshot please read these instructions carefully before use ok on dimmer outdoor ok sound activated option dmx-512 master/slave 115v/230v switch order directly today at: www.Bulbamerica.Com or call toll free 888-505-2111.

  • Page 2: Able of

    T able of c ontents 1. Before you begin...................................................................................................................................................... 3 w hat is included .............................................................................................

  • Page 3: 1. B

    1. B efore y ou b egin what is included • 1 x iled-24 • users manual unpacking instructions immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain ...

  • Page 4

    Safety instructions • please keep this user guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher th...

  • Page 5: 2. I

    2. I ntroduction features • 4-channel dmx-512 led light (with id addressing) • blackout/static/dimmer/strobe/pulse • rgb color mixing with or without dmx controller • built-in automated programs via master/slave, dmx • program and recall custom programs via master/slave, dmx • rgb fade delay channel...

  • Page 6

    Product overview 6 power out connector dmx out connector power in connector dmx in connector control panel tilt adjustment knob hanging bracket order directly today at: www.Bulbamerica.Com or call toll free 888-505-2111.

  • Page 7: 3. S

    3. S etup fixture linking you will need a serial data link to run light shows of one or more fixtures using a dmx-512 controller or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of channels required by all the fixtures on a serial data li...

  • Page 8

    Cable connectors cabling must have a male xlr connector on one end and a female xlr connector on the other end. Caution do not allow contact between the common and the fixture’s chassis ground. Grounding the common can cause a ground loop, and your fixture may perform erratically test cables with an...

  • Page 9

    Master/slave fixture linking 1. Connect the (male) 3 pin connector side of the dmx cable to the output (female) 3 pin connector of the first fixture. 2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture co...

  • Page 10: 4. O

    Mounting orientation this fixture may be mounted in any position provided there is adequate room for ventilation. Rigging it is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “c” or “o” type clamp. Adjust the angle of the fixture by loosening both knobs and...

  • Page 11

    Menu map 11 addr 1-511 shnd a0-a9 sval 1-8 blnd n bo y bo led on off fadj fadj test test fhrs fhrs 1-9999 rset rset iled order directly today at: www.Bulbamerica.Com or call toll free 888-505-2111.

  • Page 12

    Menu function menu display function values addr set the dmx address of the unit. Set between 1 and 512. Each unit is 4 dmx channels shnd sound controlled built in programs a0 to a9 sval speed/fade settings/ single color selection for shnd programs 1 to 8 blnd control on/off function of the light n b...

  • Page 13

    Shnd pre-programs sval settings a0 the leds fade continuously between the preset 12 colors in loop mode 1-8 select one fade time from 1 to 8. 1 1sec 2 2sec 3 3sec 4 4sec 5 5sec 6 6sec 7 8sec 8 10sec a1 the preset 12 colors step continuously in loop mode 1-8 select one color hold time from 1 to 8 1 1...

  • Page 14

    A4 iled -24 reacts to sound only, changing color with the music. When the music/sound stops the led parcan stays on the last color 1-8 option a5 iled -24 reacts to sound only, changing color with the music. When the music/sound stops the led parcan turns off after 10 seconds 1-8 option a6 iled -24 r...

  • Page 15: 5. A

    - dmx-512 mode if you use a universal dmx controller to control the units, you have to set dmx address from 1 to 511 channel so that the units can receive dmx signal. Press the menu button up to when the is showing on the display. Pressing enter button and the display will light on. Use “val- “ and ...

  • Page 16

    16 order directly today at: www.Bulbamerica.Com or call toll free 888-505-2111.

  • Page 17

    General maintenance to maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance a...

  • Page 18

    Technical specifications weight & dimensions length................................................................................................................... 10.9 in (277 mm) width .................................................................................................................

  • Page 19

    Size 19 order directly today at: www.Bulbamerica.Com or call toll free 888-505-2111.