Starting the Vehicle with the Remote Transmitter
Press and release button #1 (start). The parking lights will flash once, confirming the car starter received the
signal. The car will then start and the parking lights will turn on and remain on while the vehicle is running. To
shut off the engine before the preset time, press Button #4 (stop), press the brake pedal or open the hood. NOTE:
In tachless mode, parking lights will wait approximately 10 seconds before turning on after the vehicle is running.
Pit Stop: Exiting the Car with the Engine Running
Make sure the transmission is in park; press button #1 (start) before turning the ignition switch off. (The engine
will remain running for the preset time.)
Keyless Entry Operation
Press Button #2 (lock/unlock), the doors will lock and the parking lights will flash once. Press Button #2 again,
the doors will unlock and the parking lights will flash twice. The parking lights will flash and remain on for one
minute or until you turn the ignition on or press the brake.
Dome Light Option
The remote starter includes an optional output that can be used to operate the dome light when pressing Button #2,
unlock your power door locks. The dome light will remain on for one minute or until you turn the ignition on or
press the brake.
10
Trunk Release Output
The remote car starter includes an optional output from our unit that with a press and release of Button #3 will
give a pulse of (+) positive voltage for .75 seconds and if Button #3 is held down, this output will hold (+) positive
voltage on this wire until Button #3 is released. The parking lights will remain on for as long as this button is
held down. With a momentary press of this button the parking lights will flash once. This output can be used to
operate a power trunk release (part #775 may be required for some imports and some domestics), power sliding doors
and rear lift gates (part #775 may be required on some domestic and imported mini vans) operate a window roll up
module (part #706 required) or operate a power sunroof (part #775 may be required).
Runtime Confirmation (Engine Not Running)
To check programmed runtime, press and release Button #4 (stop), the parking lights will flash for the programmed
length of time. Each flash will equal 5 minutes of runtime. Example: Three parking light flashes represents 15 minutes
of runtime.