1. DL manuals
  2. Bulldog Security
  3. Remote Starter
  4. RS82
  5. Installation And Owner's Manual

Bulldog Security RS82 Installation And Owner's Manual

Summary of RS82

  • Page 1

    Contents remote starter models rs82 and rs85 installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Add...

  • Page 2

    System features system components technical assistance before you begin 1 required tools two-button extended range remotely start your car to run the heater or air conditioning from an extended distance. Remote control two-way capability works with your factory keyless remote transmitter (rs85 only)...

  • Page 3

    2 precautions since there are many different makes and models of vehicles, look at the wiring chart on page 17 in this manual and our website, www.Bulldogsecurity.Com. Read this manual thoroughly before starting the installation. You must decide if the parking light option is desired. If so, an opti...

  • Page 4

    3 4. Insert the wire(s) from the starter through the hole as shown. If two or more wires are inserted, wrap them in opposite directions. 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along...

  • Page 5

    Locating & making connections 4 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. Use this method only when connecting two separate wires end to end. Wire tie electrical tape wire tie please see the wiring chart on this webs...

  • Page 6

    5 parking light output (-) (optional part #775 required) probe the wire(s) coming from your head- lamp switch. Find the wire that will show +12v when the parking lights are on and ground when the lights are off. Connect the yellow wire from part #775 to this wire. Connect the brown wire from the 11-...

  • Page 7

    6 neutral safety switch connecting the 11-pin harness & 4-relay harness mechanical neutral safety switch when installing a bulldog remote starter on gm vehicles or dodge dakotas built prior to 1996, you must: use the diagram below to create a circuit that will prevent the remote starter from startin...

  • Page 8

    7 model rs85 operator programming instructions all of the functions and programming of the rs82, plus: programming to start your vehicle with your factory keyless entry press and hold the brake, press and hold button #1 on the bulldog security remote until the parking lights flash once (if connected...