1. DL manuals
  2. Bulldog Security
  3. Remote Starter
  4. RS82
  5. Installation Manual And Owners Manual

Bulldog Security RS82 Installation Manual And Owners Manual

Summary of RS82

  • Page 1

    Contents remote starter model rs82 installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Address 288 c...

  • Page 3

    Making wiring connections 1. Strip back two inches of insulation on the wire from the keyless entry. 2. Strip back one inch of insulation on the wire you need to connect to. One inch of bare wire two inches of bare wire 3. Separate the vehicle wire as shown. Make the separation large enough to fit t...

  • Page 4

    4. Insert the wire from the unit through the hole as shown. 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this me...

  • Page 5

    Heater/blower motor wire(s) (+12v in run position only) most vehicles will have (1) blower wire; however some fords, newer gm vehicles and chrysler 94 and up will have (2) or more blower wires. To locate these wire(s) probe for wire(s) that only show +12v when the ignition switch is in the run posit...

  • Page 6

    5 turn the parking lights to the on position. (not your headlamps). Probe the wire(s) coming from your headlamp switch. Find the wire that will show +12v only when the parking lights are on and ground when the lights are off. Connect the yellow wire from part #775 to this wire. Connect the brown wir...

  • Page 7

    6 mechanical neutral safety switch (rear wheel drive only) when installing a bulldog remote starter on gm vehicles or dodge dakotas built prior to 1996, you must: use the diagram below to create a circuit that will prevent the remote starter from starting the vehicle unless the key is removed from t...

  • Page 8

    7 for general motors cars only system 1: passkey i and ii system (1985 and up). This system has a resistor pill in the key. Measure resistance of the pill using a volt/ohm meter. A bypass module is available, part #vats-wr module. System 2: passlock i and ii system (1995 and up). Passlock does not h...