BulletHD PRO 4 Manual - Initial Set Up
Action Camera OVERVIEW
①
LED ② Power / Shutter ③ Rear Cap ④ WiFi OFF/WiFi On
⑤ USB ⑥ Micro SD Card Slot ⑦ Battery ⑧ Battery Charging LED
Initial Set Up
1. Make sure the Action Camera is OFF before adding or removing the
memory card!
2. Screw out the rear cap (open) located at the back of the Action
Camera ③.
3. Install a micro SD memory card (max up to 128GB(FAT32) into the
rear slot. To insert the micro SD card, slide the micro SD card into the
card slot on the back of the Action Camera with the card label facing
down. The micro SD card will click into place once it is inserted past
flush with the Action Camera. Use your fingernail to do this. Then
screw in the rear cap till is complete lock.
4. If no micro SD memory is inserted in the Action Camera, the LED on
top of the camera will blink red and blue.
5. When using a micro SD memory card in the Action Camera, there
should be no data from other devices on the card. If you are using a
micro SD memory card for the first time in the Action Camera, first you
should format the card in your computer.