BullFrog 2002 Spas Owner's Manual - page 15
Page 15
Bullfrog Spas Owner’s Manual
of pump 1 and again for the high speed. Press the “Jets
1” button again to turn off pump 1. If left running, the
pump’s low speed will automatically turn off after 2
hours, and the pump’s high speed will automatically
turn off after 30 minutes. The pump’s low speed runs
when the spa is heating, when a filter cycle is activated,
or when a freezing condition is detected. If the pump’s
low speed is on under Automatic Spa Control, it can
only be deactivated by entering the Standby Mode.
Note: The Auxiliary Control Pad for “Jets 1” (optional)
activates the jets in the same manner as the Master
Control Pad. (Fig. M)
Jets 2
Touch the “Jets 2” button once to activate the low speed
of pump 2 and again for the high speed. Press the “Jets
2” button again to turn off pump 2. If left running, the
pump’s low and high speeds will automatically turn off
after 30 minutes. Note: The Auxiliary Control Pad for
“Jets 2” (optional) activates the jets in the same manner
as the Master Control Pad. (Fig. M)
Light
Press the “Light” button to turn the light on and off. If
left on, the light automatically turns off after 4 hours.
Mode
This button is used to switch between Standard, Econ-
omy, and Sleep Modes.
Standard Mode is programmed to maintain the desired
temperature. Note: the last measured spa temperature
displayed is current only when pump 1 has been run-
ning for at least 2 minutes. “Std” will be displayed
momentarily when you switch into standard mode.
Economy Mode heats the spa to the set temperature
only during filter cycles. “Ecn” will display solid when
temperature is not current, and will alternate with tem-
perature when temperature is current.
Push “Jets 1” to shift to Standard-in-Economy Mode,
indicated by “SE” alternating with the temperature. The
spa operates the same as it does in Standard Mode, but
reverts to Economy Mode automatically after 2 hours.
During this time, a press of the “Mode” button will
revert to Economy Mode immediately.
Note: Heating will occur more quickly in Standard-in-
Economy Mode if a low-speed (versus a high speed)
pump is operating.
Sleep Mode heats the spa to within 20°F of the set tem-
perature only during filter cycles. “SLP” will display solid
when temperature is not current, and will alternate with
temperature when temperature is current.
Preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is
energized. The second filter cycle begins 12 hours later.
Filter duration is programmable at the Master Control
Pad for 2, 4, or 6 hours. The default filter time is 4
hours. To program, press “Warmer” or “Cooler”, then
“Mode.” Press “Warmer” or Cooler” to adjust. Press
“Mode” to exit programming.
(Figure L-2) Deluxe+ Control Pad
(Figure L-1) Deluxe Control Pad
(Figure M) Auxiliary Control Pad