BULLPRO BP-DLP500 User Manual - page 6
3
SAFETY INSTRUCTIONS
,
如浴室等潮湿的环境
- 可能导致火灾或触电。
不要堵塞通风孔。
- 可能造成投影机内部温度过度升高
而导致火灾。
为便于通风,投影机和墙之间的距离
应大于 30 厘米。
- 否则,可能造成投影机内部温度过
度升高而导致火灾。
Caution
Power
-
Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may cause a fire or an electric shock.
Do not allow a tablecloth or curtain to
block the vents.
- This may cause the internal temperature
of the projector to rise andcause a fire.
The distance between the projector
and the wall should be more than 30
cm for ventilation purposes.
- Otherwise, this may cause the internal
temperature of the projector to
rise and cause a fire.
The earth wire should be connected.
- Inappropriate earth grounding may
cause damage to the projector or
an electric shock when there is an
electrical surge.If the projector must be
installed at a place where earth grounding
is not possible, purchase a circuit breaker
and connect the projector to its wall
outlet.Do not ground the projector to the
gas pipe, water pipe, lightning rod,
or telephone line, etc.
The power plug should be fully inserted
into the wall outlet.- Unstable connection may
cause a fire.
Do not place heavy objects on the
power cord or place the cord underneath
the projector.- This may cause a fire or an
electric shock.
Never touch the power plug with a
wet hand.- This may cause an electric shock.
Do not connect too many devices to
the same power extension.
- Overheating may cause a fire.
Remove dust or contaminants around
power plug pins or wall outlets.
- This may cause a fire.
To turn off the main power, remove
the power plug, which should be positioned
so it is easy to access for operation.
•
•
•
•
•
•
•
•
•
•
•
•
When installing the projector on a
table, be careful not to place it near
the edge.Make sure that you use a stand
suitable for the size of projector.
Turn off the projector, disconnect the
power supply and remove all connections
before moving the projector.
- A damaged cord may cause a fire or an
electric shock.
Do not install the projector on an
unstable or vibrating surface such as
a vibrating shelf or tilted surface.
- It may fall and cause injury.
Be careful not to tip the projector over
When connecting external devices to the
projector.
- This may cause injury to persons or
damage to the projector.
WARNING