Summary of brinco
Page 1
The electric moto-bike user manual.
Page 2
2 3 © 2015/2016 bultaco motors s.A. , madrid, spain. All rights reserved. Printing and full or partial reproduction is prohibited without written permission from bultaco motors s.A. First of all, thank you for buying a bultaco. We are proud to have your confidence. The new brinco is a new and ground...
Page 3
4 5 important listed below is the most important information to enjoy your brinco. We recommend that you read this user manual carefully before using your brinco for the first time and consult it again every time you have any problems or questions. Your brinco is a powerful and fun vehicle that can ...
Page 4
7 1. General safety 1.1. General warnings 10 1.2. Operational safety 11 1.3. Locating power components 12 2. Vehicle description 2.1. Presentation 16 2.2. Location of components 18 2.3. Handlebar controls 20 2.4. Dashboard 22 2.5. Dashboard configuration 24 2.6. Power control button 26 2.7. Identifi...
Page 5
9 1. General safety.
Page 6
10 11 you are the only person responsible for the use of this motorbike. Do not allow other people to ride the vehicle without having received appropriate instructions and/or reading this manual. Remember that neither the seller of this brinco nor bultaco motors s.A. Can be hold responsible for the ...
Page 7
12 the power components handle voltages up to 59v that can be health hazards and potential risks of serious injury: their handling (except for assembly / disassembly and charging the battery and engine disconnection to handle the rear wheel) must only be carried out by a bultaco motors s.A. Dealer. ...
Page 8
2. Vehicle description.
Page 9
16 the bultaco brinco surprises with its innovative design, technology and the effectiveness of each of its elements. The bultaco engineering and design teams have worked together to create the first moto-bike with a spectacular, very sporty and beautiful result. From the first time you see a bultac...
Page 10
18 19 5 6 7 4 9 10 11 12 17 15 14 16 8 1 2 three-phase permanent magnet motor [see section 2.9.] mudguard reflective parts rear light license plate holder rear shifter to prevent the deralleur from coming loose always lean on it left side. Planetary gearbox [see section 3.5.] possibility of change: ...
Page 11
20 21 2.3. Handlebar controls dashboard [see section 2.3] horn control rear side mirror check proper operation before starting to drive. Front brake lever [see section 2.9 - 4.3] check the brake position properly. The front brake lever is on the right handlebar grip. Rear brake lever [see section 2....
Page 12
22 23 speedometer (km/h - mph) [see section 2.5] driving mode. Eco - sport - tour [see section 2.5] to the right of the mode the instantaneous power is shown in w. Battery level when the battery level falls below 2 bars (25% battery), the low battery indicator will be shown. Odometer / trip [see sec...
Page 13
24 25 2.5. Dashboard configuration commutation km/h - mph changing driving mode press the “mode” and “set” buttons simultaneously for more than 4 seconds. The riding mode when starting the vehicle will be eco by default. The riding mode can be changed by pressing with a short press the “mode” button...
Page 14
26 27 the power control button [see section 2.3] allows you to select and maintain the same level of power during your ride. To use the power button, you accelerate to achieve the desired power level (you can check its value on the dashboard) and then press the power control button to maintain that ...
Page 15
28 29 brinco r brinco r-e brinco c brinco s motor brushless / permanent magnets / ac / on rear wheel built-in self-protection and diagnostic system max. Power 2 kw controller 3 riding maps (sport – tour – eco) max. Speed.: 60 km/h 3 riding maps (sport – tour – eco) “45 version” max. Speed: 45 km/h 2...
Page 16
30 31 2.9. Dimensions distance between wheel centers length base height to ground seat height height release angle brinco r brinco r-e brinco c brinco s width 770 mm 735 mm distance between wheel centers 1.200 mm 1.185 mm length 1.900 mm 1.885 mm 1.830 mm seat height subchassis standard: max 1.164,2...
Page 17
33 3. General operation.
Page 18
34 35 1. Adapt the seat and handlebar height to your size so that they are in a safe and comfortable position. Make sure all items are well secured and that they are in the proper position. 2. Adjust the position of the rear side mirror to have a clear vision (just in case it is equipped with it). 3...
Page 19
36 37 connect the bultaco original charger to the battery and the power outlet (240 v ac 50hz / 110 v ac 60hz). Remember that this can be done with the batteries on the vehicle or with them removed, as shown below. 3.2. Battery charge always charge the battery with the original bultaco battery charg...
Page 20
38 39 once the charger is connected, the charging process starts automatically after 15 seconds. Do not forget to turn off or unplug the charger after use. To do this you have to press the button for 2-3 seconds and disconnect it from the network. Charging can be paused with a short press of the but...
Page 21
40 41 3.2.2. Battery charging led indicator lights operating condition during charging >80% 100% comments start with total discharge flashing main charge x further load x final charge / charge conservation x led indicator lights operating condition during charging >80% 100% error number missing batt...
Page 22
42 43 after performing the checks described in paragraph 3.1.1., your brinco is ready to start riding. To start it you must follow the procedure descibed below : 3.3. Starting your brinco 1. Place the bultaco card or wristband in the front of the dashboard where the nfc antenna is (both dashboard an...
Page 23
44 45 3.3.1. Starting card / wristband copy we will provide you with a brinco master card. This card allows you to make up to 10 card/ wristband copies. To make a copy from your master card you should purchase a blank card or wristband at your bultaco motors s.A. Dealer and follow these steps: 1. Tu...
Page 24
46 47 to get the most out of pedalling, your bultaco brinco has a transmission comprised of a planetary low range gearbox and a cassette of 9 sprockets. By combining the different gear ratios you will get the performance you need at all times. Overdrive: high gear ratio (faster). It is operated by p...
Page 25
48 49 from bultaco we would like to give you the following riding tips: avoid improper braking. It can cause serious damage to the brakes and even make you lose control of the vehicle while riding. Do not ride under the influence of alcohol or any drugs or medicines that may alter your reaction time...
Page 26
51 4. Maintenance.
Page 27
52 53 the shock absorber compresses under pressure and rebounds to recover its original length. The compression dampening is the setting that determines how fast or slow it is compressed. The rebound dampening (or bounce) is the setting that determines how fast or slow it stretches. Getting the corr...
Page 28
54 55 adjusting the fork. Rebound adjustment valve turning towards +: increases retention (slow). Turning towards -: decreases retention (fast). Preload adjustment nut turning towards +: increases spring preload. Turning towards -: decreases spring preload. Main air chamber fill with air according t...
Page 29
56 57 before the first use of your brinco you should check the condition of both brakes. First, carefully do some brake tests away from normal traffic, on a flat and non-slippery surface. Increase the brake power, little by little. Brand new braking pads require some running- in to achieve the highe...
Page 30
58 59 continuous braking without interruption, especially if it is done with a single brake, can reduce the braking power and even lead to the total failure of the brake in extreme situations. On long downhill sections you should get used to breaking with both brakes at the same time, in a brief and...
Page 31
60 61 4.4.1. Wheel change disassembles the rear side mirror. Unscrew the allen m5 screws in the handlebar. Remove the rear side mirror assembly from the handlebar. Turn your brinco upside down and place the seat and handlebars on a flat surface. Place a wooden block or similar under the handlebar gr...
Page 32
62 63 turn your brinco upside down and place the seat and handlebars on a flat surface. Place a wooden block or similar under the handlebar grips to prevent the display from touching the ground. You should also place a cloth on the seat so that it does not get stainned or damaged. Unplug the motor c...
Page 33
64 65 4.5. Transmission: chain and bottom bracket check the wear on the gear rim and sprockets. If you happen to notice that one of them has sprockets in poor condition (as indicated in the picture), go to a bultaco motors s.A. Dealer for a replacement. Check the wear on the chain. Periodically revi...
Page 34
66 67 4.7. Torques 4.8. Maintenance table task to be carried out by the user. * need to use a grease recomended by bultaco. For more information, contact with your dealer. Scheduled maintenance by bultaco. Component task to perform before each use after each use first 62 miles or 1 month every 310 m...
Page 35
69 5. Troubleshooting.
Page 36
70 71 in spite of the fact that each brinco has been carefully inspected prior to leaving the factory, there may be circumstances beyond our control that may cause some kind of failure. In the event that your brinco suffers a problem, we have provided the following indications that may help you thou...
Page 37
72 73 power control: power control lets you maintain constant power, always providing the same thrust. Use it to optimise energy consumption and battery life. Dual traction: although the pedalling and motor systems are independent, they can be combined for enhanced riding pleasure. Overdrive: use th...
Page 38
75 6. Warranty.
Page 39
76 77 the guarantor is the company bultaco motors s. A., with registered offices at calle gobelas, 13, 28028 madrid, spain. The guarantee applies only to moto-bikes have been initially placed on the market through bultaco motors s.A. Dealers of each country, meeting the regulatory requirements of ea...
Page 40
78 79 in addition, these claims are excluded from the warranty in the following situations: - if they require scheduled maintenance according to the bultaco maintenance program and if the damage was caused by the failure or delay of it to be done. - if repairs are not made in time or if not performe...
Page 41
80 81 bultaco motors s.A. By this document ensures the end-user that the motorcycle manufactured by bultaco motors s.A. Is free of defects and manufactured following the highest quality standards. Consequently, the warranty covers both parts and labour in case of the repair of any defect in material...
Page 42
Bultaco.Com.