Bultaco brinco User Manual - page 18
34
35
1. Adapt the seat and handlebar height to your size so that they are in a safe and
comfortable position. Make sure all items are well secured and that they are in the
proper position.
2. Adjust the position of the rear side mirror to have a clear vision (just in case it is
equipped with it).
3. Adapt the position of the brake levers so that you can always reach them easily. Make
sure you are very familiar with the brake lever configuration (front brake to the right / rear
brake to the left).
[See section 4.3]
4. Check the operation of the brakes. Press each brake lever individually while pushing
the vehicle to check that the wheels lock completely.
[See section 4.3]
5. Check tyre condition and pressure periodically.
[See section 4.4]
6. Set both the front and the rear suspension as you prefer.
7. With the engine stop button in the off position
[See section 2.3]
operate the
accelerator control and release it to check that it returns to its initial position.
8. Check the condition of the sprockets, transmission plate and the chain lubrication
[See section 4.5]
. Make adjustments if necessary.
3.1. Prior checks
AFTER A FALL OR A MOTO-BIKE
ROLLOVER, YOU MUST PERFORM
A COMPREHENSIVE REVIEW
BEFORE RIDING THE VEHICLE AGAIN
AND VISIT A BULTACO MOTORS
S.A. DEALER FOR A PROFESSIONAL
INSPECTION.
DETERIORATED TYRES OR
TYRES WITHOUT THE CORRECT
PRESSURE CAN CAUSE THEM
TO BURST UNEXPECTEDLY AS
WELL AS A LOSS OF CONTROL
OF THE VEHICLE. LOW PRESSURE
WILL REDUCE THE RIDE RANGE
SIGNIFICANTLY.
To make sure your Brinco is ready for use, you must perform the following checks
:
BATTERY AND CHARGER
The battery incorporates a Management System (BMS) that monitors the cell’s status
and optimises charging to provide maximum performance and a longer lifespan.
Fully charge the battery before the first use. During charging, the charger LED light will
be yellow. When the battery is fully charged, the charger LED light will turn green, meaning
that the battery is ready for use.
The battery range may vary considerably depending on conditions such as the slope of
the road and pedalling.
[See section 3.4]
If during a long trip the level of the battery charge drops to 25% of the total capacity
(2 bars on the dashboard), the battery management system will switch to ECO mode
automatically. The system will be deactivated before a complete battery discharge can
occur.
IF THE SAFETY SEAL IS BROKEN IT WILL
RESULT IN THE AUTOMATIC LOSS OF THE
WARRANTY.
FULLY CHARGE THE BATTERY BEFORE
FIRST USE.
NEVER CUT WIRES OR MODIFY ANY
OF THE POWER COMPONENTS. IT CAN
CAUSE SERIOUS INJURY.
THE BATTERY HAS A SAFETY SEAL WITH
SAFETY WARNINGS. BEING A POWER
ELEMENT, IT CAN ONLY BE HANDLED BY A
BULTACO MOTORS S.A. DEALER.
9. Check the electrical system of the vehicle (battery, motor, controller, power
wiring, front light (just in case it is equipped with it)). All wires and elements must
be in perfect condition and external connectors positioned correctly. Check the
battery charge level on the dashboard.
[See section 2.4]
If after reading these instructions you still have questions, contact your Bultaco
Motors S.A. Dealer, who will be happy to help.