Bungard CCD Original Instructions Manual - Ccd_Manual_E
ccd_manual_e
Page 27 /36
▪
Set the intensity of the dot grid
▪
Set the intensity of the table view
▪
Show the mounting holes
▪
Show the ATC tool-slots and depth sensor
•
Under the Help tab you'll find two buttons to open the location of the current project and the
documentation.
LaserPro 3000
The Bungard laser unit is an add-on-
item for the Bungard CCD to expose
photoresists, solder masks and Aluc-
orex. The laser is mounted into the
spindle holder instead of the high fre-
quency spindle and is controlled by the
RoutePro3000 software.
The Bungard laser exposure unit is an
answer to the demand of many operat-
ors for higher precision, faster pro-
cessing speeds and reduced tool costs, as it is the case for example with isolation milling.
DispPro 3000
The dispensing module DispPro3000 is an extension of the
CCD for dispensing solder paste or glue.
Instead of being controlled by a foot switch, a pneumatic
manual dispensing unit is controlled over the software Route-
Pro3000. A dosing cartridge of the dispenser is mounted into
the holder of the high-frequency spindle.
The module is not a fully automatic dispensing unit, but a dos-
ing aid for a manual dispenser.
The machine drives precisely to each dosing point and dosing
time dosing height are precisely controlled.
Further settings like viscosity control and control of the dosing volume are not supported. The control of
these parameters is subject to the user.
Document 3000
This documentation module will provide outstanding documentation which you can use for future
reference. You may also handout the project documentation to your customer along with the fin-
ished boards.
Calibrate 3000
With the calibration module, you can visually
calibrate the position of your board. The
software moves and rotates the board
according to the actual position of the
calibration marks or registration holes.
For this purpose, the machine automatically
drives to certain registration points on the
layout and the user centers the cross mark of
the camera over the mark and acknowledges
the position. Registration holes can be easily
inserted e.g. with IsoCam. Height calibration is
also possible with the help of standardized
templates.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: support@bungard.de