Bunn AFPO-2 Installation And Operating Manual

Summary of AFPO-2

  • Page 1

    Afpo-2 afpo-2 sl afpo-3 afpo-3 sl fla vor inp ut 1 2 wa ter inp ut ref ill ma in po we r 2 1 1 2 3 3 3 fla vo r ou tpu t fla vo r ou tpu t wa ter ou tpu t fla vo r ou tpu t wa ter ou tpu t wa ter ou tpu t fla vor inp ut 1 2 wa ter inp ut fla vo r ou tpu t fla vo r ou tpu t wa ter ou tpu t wa ter ou ...

  • Page 2

    2 28791 050511 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) compresso...

  • Page 3

    3 28791 071411 introduction this equipment supplies a liquid concentrate mixed with water at various ratios to the hoppers on the dispens- ers. It is for indoor use only on a sturdy counter or shelf. User notices carefully read and follow all notices on the equipment and in this manual. They were wr...

  • Page 4

    4 electrical hook-up caution – improper electrical installation will damage electronic components. 1. An electrician must provide electrical service as specified. 2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source. 3. Connect the dispenser to the powe...

  • Page 5

    5 28791 121007 5. Connect one end of input hoses to the auto refill box and the other end to the product container. Product container connectors (bib) are not supplied. Install your own interface. 6. Connect water line to auto refill box. A minimum of 20 psi (138 kpa) is required. Note: make sure al...

  • Page 6

    6 fla vor inp ut 1 2 wa ter inp ut ref ill ma in po we r 2 1 1 2 3 3 3 fla vo r ou tpu t fla vo r ou tpu t wa ter ou tpu t fla vo r ou tpu t wa ter ou tpu t wa ter ou tpu t mix ratio (water/flavor) time for flavor output (1/2 cup) time for water output (1 cup) 1+1 assume 20 sec. Or obtain time per n...

  • Page 7: Operating Controls

    7 fla vor input 1 2 wa ter inp ut refill ma in po we r 2 1 1 2 3 3 3 fla vo r ou tpu t fla vo r ou tpu t wa ter ou tpu t fla vo r ou tpu t wa ter ou tpu t wa ter ou tpu t operating controls a. Main power on/off the main power on/off switch is located on the right of the front panel just above the po...

  • Page 8

    8 piping diagram (afpo-2) 28791 121007 the only difference between the afpo-2/3 and afpo-2/3 sl is the sl models have a water output line and a flavor output line for each product. This allows the water and flavor to be mixed in the hoppers. Refer to the illustration below when connecting the lines..