1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. FMD-1
  5. Installation And Operating Manual

Bunn FMD-1 Installation And Operating Manual

Summary of FMD-1

  • Page 1

    Fmd-1 fmd-2 s/n fmd0013000-up installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming ...

  • Page 2

    2 29112 050511 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) compresso...

  • Page 3

    3 introduction this equipment dispenses hot beverages or soups on demand from powered product. It is for indoor use only on a sturdy counter or shelf. 00656.0001 00831.0000 fmd-1 28328.0004 28368.0003 fmd-2 28328.0005 27096.0000 fmd-1 only 28964.0000 28964.0001 29112 051111 control thermostat adjust...

  • Page 4

    4 initial set-up 1. Locate the drip tray assembly beneath the dispenser nested in the packing material. 2. Remove the drip tray and the drip tray cover and set them aside. 3. Remove the water strainer assembly from the drip tray and set it aside. 4. Remove the four legs from the packaging material, ...

  • Page 5

    5 initial fill & heat caution - the dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Turn-on the water supply and connect the dispenser to the power source. 2. Water will automatically flow into the tank to the proper l...

  • Page 6

    6 cold beverage set-up (optional fmd-2 only) cold beverages may be dispensed from the left dispense position as follows: 1. Disconnect the dispenser from the power source. 2. Remove the lower front access panel. 3. Locate the hot/cold jumper connection near the whipper panel in the main wiring harne...

  • Page 7

    7 29112 060509 cleaning the use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur- faces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 1 x 24h 37254.0000a 07/04 © 2004 bunn-o-matic corporation notice the cleaning ...

  • Page 8

    8 adjustments the beverage solenoid is preset to dispense approximately one ounce per second. This amount can be adjusted: 1. Disconnect the dispenser from the power source. 2. Remove product hopper(s). 3. Remove the hole plug(s) in the auger motor mounting panel. 4. Rotate the control at the base o...