1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. FMD-3
  5. Installation And Operating Manual

Bunn FMD-3 Installation And Operating Manual

Summary of FMD-3

  • Page 1

    Fmd-3 (s/n fmd0013000-up) installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manu...

  • Page 2

    2 29170 050511 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) compresso...

  • Page 3: Warning

    3 introduction this equipment dispenses hot beverages or soup on demand from powdered product. It has three hoppers. This equipment may also dispense cold beverages from powdered product from the left dispense station. It is for indoor use only on a sturdy counter or shelf. 00831.0000 28301.0003 war...

  • Page 4

    4 initial set-up 1. Locate the drip tray assembly above the dispenser nested in the packing material. 2. Remove the drip tray and the drip tray cover and set them aside. 3. Remove the water strainer assembly from the drip tray and set it aside. 4. Remove the four legs from the packaging material, ap...

  • Page 5

    5 plumbing requirements this dispenser must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kpa) from a 1/2˝ or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure is grea...

  • Page 6

    6 initial fill & heat caution - the dispenser must be disconnected from the power source throughout the initial fill & heat, except when specified in the instructions. 1. Turn on the water supply and connect the dispenser to the power source. 2. Water will automatically flow into the tank to the pro...

  • Page 7

    7 cold beverage set-up (optional) cold beverages may be dispensed from the left dispense position. Simply place the hot/cold switch near the left whipper chamber in the “cold” (upper) position. Adjustments the hot or cold beverage solenoids are preset to dispense approximately 9 / 10 ounce per secon...

  • Page 8

    8 cleaning the use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur- faces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 1 x 24h 37254.0000a 07/04 © 2004 bunn-o-matic corporation notice the cleaning instructions ...

  • Page 9

    9 draining the hot water tank caution - the dispenser must be disconnected from the power source throughout these steps. 1. Disconnect the dispenser from the power source. 2. Open front door and place tank heater switch in the “off” (upper) position. 3. Shut off and disconnect the incoming water sup...