Itcb itcb-dv infusion series ® installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming...
Page 2 36748.1 112008 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) co...
Page 3 introduction this equipment will brew either tea or coffee into an awaiting dispenser or reservoir. It can be easily configured for 120v 15 amp, 120/208v 20 amp or 120/240v 20 amp. The brewer may have an auxiliary hot water faucet. It is only for indoor use on a sturdy counter or shelf. The i...
Page 4 user notices carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels. For 120/208v or 120/240 volt operation, replace power supply cord only with bunn-o-matic part number ...
Page 5 electrical hook-up (all models) caution – improper electrical installation will damage electronic components. Damage caused by incor- rect electrical connections is not covered by warranty. 1. An electrician must provide electrical service. 2. Determine the available on-site electrical servic...
Page 6 tank drain 1. Remove back access cover. 2. Close the white shutoff clamp on the long hose between tank and inlet solenoid. 2. Disconnect the hose clamp and hose from inlet solenoid. 3. Place the end of the drain hose in a container that has a minimum capacity of [3.5 gallons/13.25 l singles] ...
Page 7 operating controls a. On/off switch pressing the "on/off" pad will alternately turn the brewer on and off. Pressing this pad during the brew cycle will interrupt the brew cycle, stopping the flow of water. Pressing this pad during programming of the brewer will exit the setup and return to th...
Page 8 1. Insert an empty funnel into the funnel rails. 2. Place an empty server under the funnel. 3. Connect the brewer to the power source. Make sure the on/off switch is on (led will be lit). 4. Water will flow into the tank and stop when the tank is filled to its capacity. Display will show plea...
Page 9 tea brewing 1. Begin each brew cycle with a clean empty brew funnel and server. (be sure the server lid doesn’t interfere with the flow of dilution water.) 2. Insert a bunn filter into the funnel. 3. Pour the packet of loose fresh tea leaves into the filter. Approximately three to five ounces...
Page 10 cleaning caution – clean and sanitize your iced tea brewer daily 1. Remove and thoroughly clean the entire brew funnel. The funnel tip and screen must be free from any tea particles or residue. Reassemble the funnel. 2. Remove and thoroughly rinse the sprayhead. The holes must be open and cl...
Page 11 sanitizing optional sweetener all models: 1. Remove all the quick disconnects (qcd) from all the b.I.B. Containers. 2. Fill a suitable pail or bucket with a warm soapy tap water solution. (140° f) 3. Submerge all disconnects (gas and liquid) in the soapy solution and then clean them using a ...
Page 12 programming using the menu-driven display on the front of the brewer, the operator has the ability to alter or modify various brewing parameters such as brew temperatures, brew volumes, dilution volumes, pulse brew, etc. This allows for the precise brewing of various flavors of tea and coffe...
Page 13 36748.1 112608 main screen this screen will be shown when the brewer is ready for use. The screen displays the water temperature in the tank. When the water in the tank reaches the correct set temperature, the display will change from heating to ready to brew. Programming lockout switch ((lo...
Page 14 brew a brew b brew c brew a brew b brew c brew a brew b brew c brew a brew b brew c brew a brew b brew c spray oz/m: xx.X (-) done (+) (-) done (+) calibrate flow? No yes brew counters? No yes programming the brewer (cont.) programming functions - level i programming functions - flow chart p...
Page 15 麦乐嘉酒店用品（深圳）有限公司 电话 Ｔｅｌ：０７５５－８２４０８３７７，２５９２２６９９－８１０ 麦乐嘉酒店用品（深圳）有限公司.
