1. DL manuals
  2. Bunn
  3. Kitchen Appliances
  4. TB3
  5. Installation & Operating Manual

Bunn TB3 Installation & Operating Manual

Manual is about: TB3 TB3-LP OPERATING & SERVICE MANUAL

Summary of TB3

  • Page 1

    Tb3/tb6 series including: tb3; tb3-lp; tb3q; tb3q-lp; tb6; tb6q starting with serial number: tu00020000 installation & operating manual bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of t...

  • Page 2

    Page 2 41465.1 080112 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcp/mca pod brewers thermal servers and thermofresh servers (mechanical and di...

  • Page 3

    Page 3 #00831.0000 #00656.0001 #03408.0000 #03409.0000 #37881.0000 • fill water tank before energizing • do not overload circuit • keep away from combustibles • do not deform plug or cord • failure to comply risks equipment damage, fire or shock • brewer energized unless unplugged see instructions w...

  • Page 4

    Page 4 electrical requirements caution - the brewer must be disconnected from the power source until specified in initial set-up. 120v model brewers require 2-wire, grounded service rated 120 volts ac, 15 amp, single phase, 60 hz. "a" model brewers require 2-wire, grounded service rated 220-240 volt...

  • Page 5

    Page 5 120v models these brewers must be connected to a cold water system with a minimum 1.0 gpm flow rate, and operating pressure between 20 and 90 psi (138 and 620 kpa) from a ½˝ or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the l...

  • Page 6

    Page 6 initial set-up (tb3q/tb3q-lp/tb6q only) caution - the brewer must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Remove the top cover from the brewer. 2. Rotate the control thermostat knob fully counterclockwise to the "off" ...

  • Page 7

    Page 7 initial set-up (tb3/tb3-lp/tb6 only) caution - the brewer must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Remove the top lid from the brewer. 2. Rotate the control thermostat knob fully counterclockwise to the "off" posit...

  • Page 8

    Page 8 auto sweetener set-up caution - the brewer must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Remove the top lid and both rear panels. 2. Make sure the brewer water supply is off. 3. Connect sweetener hose from the bag in a ...

  • Page 9

    Page 9 adjusting brew volumes note: check that the brewer is connected to water supply, the tank is properly filled, and a funnel and server are in place, prior to setting or modifying batch sizes. 1. To adjust concentrate volume on tb3/tb6 models, and dilution volume on tb3q/tb6q models: modifying ...

  • Page 10

    Page 10 operating controls a. On/off switch on - placing the switch in the left position allows the start switch to activate a timed brew cycle for three gallons of tea. Off - placing the switch in the right position stops the brew cycle. Stopping a brew cycle after it has been started will not stop...

  • Page 11

    Page 11 41465.1 042009 cleaning caution - clean and sanitize your iced tea brewer daily daily: 1. Remove, disassemble and thoroughly clean and sanitize the entire brew funnel. The funnel tip and screen must be free from any tea particles or residue. Reassemble the funnel. 2. Place the on/off switch ...