C.A.R.D. 60 Installation And Operation Manual - Www.Survivalsafety.Com
of
16
light from the signal reflected from the coast as well as one from
the primary source. Again, by rotating the sensitivity knob a few
degrees clockwise, the reflected signal should disappear.
A remote horn can be installed using the pin #7 of the antenna
plug.
Remove the shell covering plug.
Locate pin #7 (this is the only one without a wire).
Connect a wire to the negitive side of the buzzer.
The positive side of the buzzer is connected to the positive side of
your battery.
We recommend that you install an on-off switch in the 12 volt
line, to turn off the remote when not needed.
For help with this installation please call SSE for assitance at:
1 - 888 - 475-5364
Voice: 757 - 480-5508
www.survivalsafety.com
survivalsafety@cox.net
Page# 11