C.A.R.D. 60 Installation And Operation Manual - Control Module
of
16
CONTROL MODULE
WARNING
The Display Module IS NOT WATER RESISTANT !
When choosing a location find one that remains dry.
Your navigation station should qualify.
Mount the control module in a convenient location where you
can observe the display .
Connect the power cable to a reliable power source of 12 volts
D.C..
It is suggested that you run the power cable to your distribution
panel and not parallel to any other circuits .
Connect the red wire to positive and the black wire to the ground.
For further protection a 1/4 amp fuse can be installed either in
line or at the distribution panel.
Page# 8