C.E.C. DA3N Owner's Manual - page 21
DA3N User's Manual
1
Troubleshooting
If you suspect a malfunction in the unit, please check the following chart
before calling your dealer.
●
No power
Check the connection at the both ends of the AC power cord.
Make sure there is power at the wall outlet.
Note: Turning the power on/off repeatedly may cause this. Wait for 5
seconds before turning the power on again.
●
No sound
Check the connection from the external sources, e.g. CD transport.
Check the operation of the external sources, e.g. CD transport.
Check the connection to the amplifier, speakers or headphones.
Check whether the matching input is selected.
Check the position of the input selector on the amplifier.
If Variable output is connected, check VOLUME position.
●
Hum noise or distortion
Check if the plugs are connected correctly.
Make sure correct cable is used in the specific direction.
●
Interference on the tuner
The tuner is too close to the DA3N. Install the DA3N away from it
or turn off the tuner’s power.
●
Unresponsive to remote control
Point the remote control towards the remote sensor on the front
panel.
Remove any objects blocking the sensor.
Use the remote control unit at a shorter distance from the DA3N.
Replace the batteries in the remote control unit with new ones.
●
DA3N contains a microcomputer that can malfunction due to the external
noise or interference. If this seems to be the case, turn the unit off and wait
for a short while before turning it back on and trying again.