C&K Systems SYS3316RF Installation Instructions Manual

16.5 VAC

25 - 40 VA

50-60 Hz

Protected by Fuse

F2: 3 AG, 0.75 A

Shared with keypads

and AUX Power

UNSWITCHED

AUX POWER

KEYPAD INFORMATION

Do not exceed 4 keypads

or max AUX POWER

Protected by Fuse F3:

3 AG, 0.75 A

RED

RED

RED

RED

RED

BLK

BLK

BLK

BLK

BLK

BATTERY

BATTERY

BATTERY

BATTERY

BATTERY

Capacity for

Capacity for

Capacity for

Capacity for

Capacity for

emergency

emergency

emergency

emergency

emergency

standby at

standby at

standby at

standby at

standby at

least 4 hours

least 4 hours

least 4 hours

least 4 hours

least 4 hours

CAUTION: Total power from

Terminals 3, 5, 7, and 8 NOT

to exceed 750 mA, combined.

NOTE: Z7 and Z8 must be

wired manually to the panel.

All ratings listed on this page are in compli-

ance with UL 985, UL 1023, and UL 1635.

DIRECT

CONNECT

WATCH

DOG

DS1

DS1

DS1

DS1

DS1

WARNING:  

Circuit

Damage May Result

From Incorrect

Wiring Connections.

Red = incoming ring

Green = incoming tip

Gray = seized ring

Brown = seized tip

Blue = tamper

Orange = tamper

WARNINGS:

WARNINGS:

WARNINGS:

WARNINGS:

WARNINGS:

For continued protection

For continued protection

For continued protection

For continued protection

For continued protection

against risk of fire,

against risk of fire,

against risk of fire,

against risk of fire,

against risk of fire,

replace fuses only with

replace fuses only with

replace fuses only with

replace fuses only with

replace fuses only with

fuses of same type and

fuses of same type and

fuses of same type and

fuses of same type and

fuses of same type and

rating

rating

rating

rating

rating

PHONE   CORDS

PHONE   CORDS

PHONE   CORDS

PHONE   CORDS

PHONE   CORDS

Use either:

- 9.X PCF

- 9.X PCP

U14

U14

U14

U14

U14

U6

U6

U6

U6

U6

F1     2.5A BELL FUSE

  F2     0.75A AUX  DEVICES

F3     0.75A KEYPAD

SN913-I/O

PROTECTED

BY FUSE F2:

3AG, 0.75A

P/N 5-051-396-00  Rev A

P/N 5-051-396-00  Rev A

P/N 5-051-396-00  Rev A

P/N 5-051-396-00  Rev A

P/N 5-051-396-00  Rev A

- All outputs are power limited

- Connect ground wire from door hinge to earth ground using

16 AWG, green jacketed, solid-conductor wire

- If programmed for EOL or Supervised loop, the 2.2K ohm EOL

resistor (Model 9.X, 2.2K) must be at end of circuit

GENERAL INFORMATION

GENERAL INFORMATION

GENERAL INFORMATION

GENERAL INFORMATION

GENERAL INFORMATION

- Loop voltages:

- Loop 8 can be used as standard loop or used for switched 10-

12.5 VDC at 50 mA for 2-wire powered devices.  Loop 8 can

support up to 10 BRK Model 2400 2-wire smoke detectors.

Loop 7

0 - 2 VDC = short

2 - 3 VDC = normal

3 - 5 VDC = open

Loop 8

0 - 2.5 VDC = short

2.5 - 8.5 VDC =

normal

8.5 - 15 VDC = open

- SN913-I/O card requires 2.2 K ohm resistor (P/N 5-162-024-00)

-

   are electrically common

  4  3  2

1

S1

TX

GND

V+

RX

ON

SWITCHED

AUX POWER

10 - 12 VDC

Protected by

Fuse F2:

3 AG, 0.75 A

12 VDC

6.5 AH or 9.5 AH

sealed lead-acid

POWER SUPPLY INFORMATION

- For non-Cal-Fire requirements, only use 12 VDC, 6.5 AH sealed

lead-acid battery, C&K Model #1265.

- For Cal-Fire Installations, use 12 VDC, 9.5 AH, sealed lead-acid

battery, C&K Model 1295.

- Replace battery every 3 - 5 years  with C&K Model 1265 or 1295.

- Power demand for AUX POWER, keypads, and sounders not to

exceed maximum ratings.

- Install transformer (C&K Model 1097-B) on unswitched power

recepticle.

- Remove AC and battery power before replacing fuses.

- Maximum battery charge current = 350 mA.

- Standby battery time table with 1 Alpha keypad:

Battery

Time

Current

6.5 AH

7.5 Hrs.

500 mA

12 Hrs.

200 mA

9.5 AH

12 Hrs.

450 mA

24 Hrs.

  56 mA

SYS3316RF Installation Instructions

SYS3316RF Installation Instructions

SYS3316RF Installation Instructions

SYS3316RF Installation Instructions

SYS3316RF Installation Instructions

AUDIBLE

10.5-13.5 VDC

Protected by Fuse

F1: 3AG, 2.5 A

Fuse F4 3 AG,

3 A battery

protection