Cable Electronics MP75 Instruction Manual - page 11
10
FAQ
Q: Why can’t I see any video on the HDMI monitor?
The unit may be set to output on the Composite, Component, or VGA Video
output ports. The MP75 does not support dual simultaneous output. The Video
Output Mode must match the type of cable and monitor attached to the player.
Do not connect more than one output at a time to the player. This will degrade
the output quality. Remove the storage device to stop playback and press the
desired A/V output button on the remote to change.
Q: The unit will not play my files but I can see them on the computer?
The SD card may have corrupt files on it that could confuse the player. Reformat
the SD card and reload your content. (Do not use “Quick Format”)
Please check if the media files are the formats supported by the media player
(Media files format please refer to 2.2 Specifications.)
Q: How do I change photo transitions, or rotation, or slide display
length?
Sorry, these parameters are fixed and are not user adjustable.
Q: There is a display, but the brightness is very low, why?
It is very likely that there is more than one video output cable connected. Only
connect one video output cable at a time for maximum performance.
Q: How do I change Video Output? The buttons on the remote don’t
work.
The output may be changed by going to setup and changing the video output
in the menu, or you may use the direct access buttons on the remote. Before the
direct access buttons are active, you must stop playback and remove the
memory card from the MP75. Change to the desired output and reinsert the
memory card.