Cablecraft CHT 400 Instruction Manual - Hydraulic Crimping Tool
6
(2 ) Eliminate breakdown Q & A:
1. Q:How to add oil in the inside of tool when the oil is not full enough?
A:What was the cause of shortage of oil inside?
<1> It causes the oil evaporated by using for a long period.
<2> It causes leak oil by improper uses or moving.
Condition <2>: Please return the tool to supplier.
Condition <1>: Please follow below steps (Figure 5, Figure 6, Figure 7,and
Figure 11) for adding oil.
Figure 5. Take out the Fixed Handle Figure 7. Add oil
Finish adding oil, please reassemble the parts in sequence.
2. Q:The die cannot be positioned while pressing.
A:The causes are:
<1> Shortage of Oil Please fill in oil in the reservoir up to full.
<2> Air inside Please add oil in the reservoir up to full.
<3> Impurities inside the reservoir
Exchange new Hydraulic oil.
<4> Impurities inside the tool Take apart the inner parts and clean
them. Then reassemble them.
HYDRAULIC CRIMPING TOOL
INSTRUCTION MANUAL
Figure 6.
Take out the
plug