Cablesson HDelity User Manual - page 13
21 | Operational Approach
METHOD C: SOFTWARE CONTROL THROUGH RS-232 PORT
22 | EDID Learning
EDID LEARNING
10. Default Reset Button
Click this button to do Factory Default Reset
The Default Reset process will take about 80~90 seconds
11. In/Out Switch Button
A.
Click the button on the checkerboard to select
Input & Output port
B.
User can click the input number button to let all
outputs select the same input
Ex: All outputs select input 3
12. Mute Output Button
A.
Click the circle button to turn-off output’s video
and audio
Ex: Mute Output 2
The EDID Learning function is only necessary whenever you encounter any display on the HDMI output port that cannot
play audio and video properly. Because the HDMI source devices and displays may have various level of capability in
playing audio and video, the general principle is that the source device will output the lowest standards in audio format
and video resolutions to be commonly acceptable among all HDMI displays. In this case, a 720p stereo HDMI signal
output would be probably the safest choice. Nevertheless, the user can force the Matrix to learn the EDID of the lowest
capable HDMI display among others to make sure all displays are capable to play the HDMI signals normally.
There are
THREE methods to do EDID Learning as below,
1. Front Panel Push-in Button: Please refer to the Operation Approach\Method A: Push-in Button
2. IR Remote Control: Please refer to the Operation Approach\Method B: IR Remote Control
3. Software Control: Please refer to the Operation Approach\Method C: Software Control through RS-232
port
There are eight embedded Default EDID as below:
1. Full-HD (1080p@60) - 24 bit 2D & 2 ch
2. Full-HD (1080p@60) - 24 bit 2D & 7.1 ch
3. Full-HD (1080p@60) - 24 bit 3D & 2 ch
4. Full-HD (1080p@60) - 24 bit 3D & 7.1 ch
5. HD (1080i@60) (720p@60) - 24 bit 2D & 2 ch
6. HD (1080i@60) (720p@60) - 24 bit 2D & 7.1 ch
7. Full-HD (1080p@60) - 36 bit 2D & 2 ch
8. Full-HD (1080p@60) - 36 bit 2D & 7.1 ch