Cabletron Systems LR-2000 User Manual - page 13
CONNECTING THE LR-2000
Page 3 - 2
Figure 3-1. Cable Support Installation
4.
Attach an AUI cable (2, 8), no longer than 50 meters in length, to both transceivers
connected in step 3.
5.
Connect the AUI cable (2) from transceiver 1 (1) to AUI port 1 (3), located on the
back side of the LR-2000.
6.
Connect the AUI cable (8) from transceiver 2 (9) to AUI port 2 (5).
7.
Plug the power cord (7) into the power receptacle (6) located on the back side of
the repeater.
8.
Plug the power cord into a wall receptacle.
9.
Turn the power switch, located next to the power receptacle, to the ON position.
The PWR LED, indicating that the repeater is receiving power, and the XCVR PWR
LED, indicating that the repeater is providing power to the transceivers connected to
it, should be lit.
10. Using the cable ties provided, strain relief both AUI cables and the power cord to the
cable supports located on the back side of the repeater.
The LR-2000 is now ready for operation. It is recommended that the connections be tested
prior to transmitting data. Refer to Chapter 4, Testing and Troubleshooting.