Cabletron Systems RoamAbout User Manual - Showing Current Settings
Showing Current Settings
4-4 Configuring the RoamAbout Access Point
Showing Current Settings
You can display the settings that the AP is currently using.
Using the AP Manager, select the AP in the Managed List field and click the various
buttons, such as Wireless Parameters, Operating Modes, IP Network Parameters,
and Hardware.
In the Wireless Parameters dialog, click the Advanced button to view all the wireless
parameters. If you see a Normal button instead of Advanced, the dialog is currently
displaying all the wireless parameters. If you have changed any wireless parameters
and have not yet reset the AP, the operating (current) settings are displayed on the left
and the settings that will take affect after the next reset are on the right.
Using the console port, choose Show Current Settings to display the current AP
settings, as shown below.
=================================================================
RoamAbout Access Point,Wireless-to-Wired Bridge:HW=V1.0,RO=V1.4,SW=V4.
n
SysUpTime : 00:26:37 98 resets
SNMP Read/Write Community : public
Console Password : Disabled
SNMP Trap Addresses : Not Configured
In-Band Interface Hardware Address : 08-00-2B-A3-89-61
In-Band Interface IP Address : 16.20.40.156
In-Band Interface Subnet Mask : 255.0.0.0
In-Band Interface Default Gateway : Not Configured
Wired Ethernet MAC Address : 08-00-2B-A3-89-61
Wireless Ethernet MAC Address : 00-60-6D-92-00-FB
Wireless Network Adapter : RoamAbout IEEE 2.4 GHz DS
Adapter Revisions : Hardware 2.000 Firmware 3.01
Bridge Mode : Work Group
Upline Dump : DISABLED
Memory : 4194304 bytes
===================================================================
Press Return for Main Menu ...